Top-rated drywall insulation pros.

Get matched with top drywall insulation pros in Lamesa, TX

Enter your zip and get matched with up to 5 pros

Need a pro for your drywall insulation project in Lamesa, TX?

Select your specific project to find the pro for you.

Find Drywall insulation pros in Lamesa

Avatar for Super Fill Insulation LLC
Super Fill Insulation LLC
5.0(
69
)
Blown-In Insulation - Install or UpgradeInjection Insulation - Install

Serving Lamesa, TX and surrounding areas

Approved

Super Service Award Winner

In business since 1982

Free estimates

Credit card accepted

"Marcus and his company insulated my walls and attic. I had no idea that I didn’t have any insulation in some areas. Marcus went above and very beyond his work scope. He worked hard and did it right. I’m so pleased with his work ethic and honesty!! My inside walls weren’t damaged in any way. No Sheet-rock repairs necessary. I highly recommend this company!!"
Inside Garage
Attic
Exterior
Exterior
Response time4 days
25 neighbors recently requested a quote
Recommended by80%of homeowners
BluSky NM Drywall Lath & Plaster Inc
4.8(
249
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Lamesa, TX and surrounding areas

In business since 1994

Free estimates

Emergency services offered

"The crew showed up every morning on time. They patched/drywalled and textured numerous small areas. The texturing was so good, that it is almost impossible to detect where the repairs where made. They also framed, drywalled and textured the kitchen area for recessed lighting installation. They repaired an area where there was a shower leak. They replaced the drywall and textured an area where a closet had been removed. On every part of the project, they exhibited superior workmanship. And at the end of every day, they cleaned up after themselves. Hire them again? Definitely yes! 
"
Additional Photos
Additional Photos
Additional Photos
Recommended by98%of homeowners
Avatar for Urethane USA Insulation & Coatings, LLC
Urethane USA Insulation & Coatings, LLC
4.6(
10
)
Injection Insulation - Install

Serving Lamesa, TX and surrounding areas

In business since 2016

Free estimates

Warranties offered

"UrethaneUSA did what they said were going to do according to the bid. The crew showed up on time as promised and did a wonderful job. Both the installation crew and support staff stayed after hours and cleaned up the area. My sales person Sam Collins met with me days before to see the project site and discuss pros and cons of the different types of foam insulation and how it would best benefit my project."
Residential Spray Foam Project
Residential Spray Foam Project
Residential Spray Foam Project
Residential Spray Foam Project
Residential Spray Foam Project

+36

Response time2 days
Recommended by100%of homeowners
Double T Foam, LLC
5.0(
4
)
Injection Insulation - Install

Serving Lamesa, TX and surrounding areas

In business since 2020

Free estimates

Offers commercial services

We take great pride in our experience, expertise, quality, and customer service that we provide to meet the consumer's needs. It is our mission to provide excellent workmanship and complete customer satisfaction from start to completion of a project. In order to understand the needs and expectations of our customers, we take great care to work and communicate with every customer in a professional manner. Our reputation is based on service, safety, and quality, regardless of how large or small the job.

Response time8 hrs
Recommended by100%of homeowners
Avatar for J&M SPRAY FOAM TECHS
J&M SPRAY FOAM TECHS
5.0(
8
)
Blown-In Insulation - Install or UpgradeInjection Insulation - Install

Serving Lamesa, TX and surrounding areas

In business since 2009

Free estimates

Small jobs welcome

"Highly recommend J and M Spray Foam Techs. We are very pleased with the work these guys did with my mom s spray foam insulation in her building. She was very happy with the end result! They were very professional. Showed up on time and did an excellent job cleaning up after."
River of Hope Church
River of Hope Church
River of Hope Church
River of Hope Church
River of Hope Church

+25

Response time1 day
Recommended by100%of homeowners
Avatar for ADT Solar
ADT Solar
4.4(
111
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Lamesa, TX and surrounding areas

In business since 2008

Free estimates

Warranties offered

"MARC JONES CONSTRUCTION TEAM  ARRIVED ON SCHEDULE AND INSTALLED THE SOLAR ARRAY OVER TWO DAYS.  ON MONDAY, WE HAD INSPECTION AND A FEW DAYS LATER THE ATTIC WAS INSULATED WITH FOAM TO REDUCE HEAT LOAD ON AIR CONDITIONING SYSTEM.  EVERYTHING WENT SMOOTHLY EXCEPT FOR INADVERTANTLY UNPLUGGING THE SYSTEM CIRCUITBREAKER DURING THE FOAMING OPERATIO.
"
11 kW PV Installation
5 kW PV Installation
9.5 kW PV Installation
Recommended by89%of homeowners
Avatar for CB Foam
CB Foam
5.0(
3
)
Injection Insulation - Install

Serving Lamesa, TX and surrounding areas

In business since 2020

Free estimates

Credit card accepted

We take great pride our experience, expertise, quality and customer service that we provide to meet your needs. It is our mission to provide excellent workmanship and complete customer satisfaction from start to completion of a project. In order to understand the needs and expectations of our customers, we take great care to work and communicate with every customer a professional manner. Our reputation is based on service, safety and quality, regardless of how large or small the job.

Spray Foam Insulation
Spray Foam Insulation
Spray Foam Insulation
Response time4 hrs
Recommended by100%of homeowners
Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,688
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Lamesa, TX and surrounding areas

In business since 1971

Credit card accepted

"Well, the first time the replacement was ordered it was the wrong one, which of course, delayed the installation a week. When it was finally installed I had to pay an additional $850 for code upgrades. This I was not informed of by Home Shield. Then we noticed that there was water on the garage floor and found that the pipe coming in from the wall was leaking at the wall so had to call the plumbing company back out to fix it. They first tried to say it was not their fault but since there wasn't a leak before they installed they did fix it. I have used Home Shield a few times before and never had a problem. Some of the companies they use are not the best so you have to research them before you commit. I have found HS service to be good if you do your homework. At the end of the day I was without hot water for almost 3 weeks but it was do to the plumbing company they sent out."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Avatar for AIR NETWORK A/C & HEATING
AIR NETWORK A/C & HEATING
5.0(
10
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Lamesa, TX and surrounding areas

In business since 2003

Free estimates

Emergency services offered

"I received 3 quotes on installing a new 5 ton unit to our house air network was $2,000 cheaper than the # 2 bid and over $3000 cheaper than the other bid. They came when they said and chris was very knowledgeable. We had a new unit installed as well as all new ducting and blown in insulation. I would highly recommend air network in the Weimar area"
Recommended by100%of homeowners
Avatar for Alpha Insulation
Alpha Insulation
New to Angi
Blown-In Insulation - Install or UpgradeInjection Insulation - Install

Serving Lamesa, TX and surrounding areas

In business since 2001

Free estimates

Alpha Insulation proves insulation and roofing service for our local residents and businesses. Customer satisfaction is what determines our success, which is why we take a hands-on approach and keep the customer informed through every phase of the project. When interacting with our company, you'll notice that we're particularly focused on the principles of quality workmanship, timely completion, competitive pricing and integrity in all our business dealings. We combine knowledge and research with our extensive practical experience to ensure a specialized approach for your project needs. Contact us today for a fair and accurate estimate of your project. We look forward to adding you to our long and growing list of happy customers.\nAlonzo Aranda 432-238-7717

For All Homes
Foam Insulation
Foam Insulation
Foam Insulation
Foam Insulation

+1

Response time5 days
Showing 1-10 of 17
Drywall Insulation questions, answered by experts

You should always hang drywall from the top down. Starting at the top makes it easier to create a straight, tight line between the ceiling and the wall. Any gaps that occur will be at the bottom, where they are easier to manage. You can either cut the bottom piece of drywall to fit the remaining space or cover the gap with baseboard trim. Additionally, starting at the top is physically easier, as you won't have to fit the top sheet into a tight space between the lower sheet and the ceiling, or try to balance the upper sheets on the lower ones while securing them.

Textured walls are a great way to hide imperfections left over by drywall installation, but many homeowners feel like it’s an outdated look, despite there being so many types of drywall texture. And while the textured walls of today are a far cry from the popcorn ceilings and faux stucco of our grandmother’s homes, if you want a more modern look or you want to install wallpaper, it’s time to smooth out your walls.

It is possible to apply plaster on the interior or exterior of your home, but we don’t recommend it. Plaster is easy to apply in theory, but in reality, it can be a challenging material to work with, and it’s difficult to get the finished product to look clean, even, and smooth. Many DIYers end up calling in a professional afterward to touch up the area or even redo it entirely because of mistakes they made in the process. Hiring a plaster pro will cost more, but it’s usually the best option to achieve high-quality results.

The easiest way to tell if a wall is load bearing is to check if it’s an exterior wall or if it runs perpendicular to the joists above and below it (or parallel to beams). Exterior walls are almost always load-bearing, and walls that run under beams or parallel to them are also usually load-bearing. There are exceptions to these rules, and walls that don’t fit into these categories can still be load-bearing. If you’re unsure, hire a structural engineer to look at your home to assess whether or not the wall is structural.

Plastering and skimming are two different techniques for finishing walls. Plastering involves applying a thick layer of a plaster mixture—typically containing gypsum, lime, cement, sand, and water—to create a new surface. This process often requires multiple coats and is used for repairing significant damage or creating decorative textures. Skimming, on the other hand, is a technique that involves applying a thin layer of drywall compound or joint compound over an existing surface to smooth it out, covering minor imperfections, small cracks, or uneven textures for a polished look. Plastering is generally more costly and labor-intensive than skimming. Although some people use the terms interchangeably, they refer to different processes and materials.

The Lamesa, TX homeowners’ guide to drywall insulation services

From average costs to expert advice, get all the answers you need to get your job done.