Get matched with top countertop and backsplash pros in Jasper, TX

The frequency for sealing marble countertops depends on several factors, including the quality and color of the stone, the type of sealant used, and the amount of traffic the surface receives. Marble has a porous surface that requires sealing to maintain its shine and resist scratches. As a general rule, you should seal countertops at least once a year. However, for heavily used surfaces, like those in a busy kitchen or family bathroom, you may need to reseal them every three to six months. Conversely, countertops in a rarely used guest bathroom might only need resealing every few years.

Yes, you can install a farmhouse sink on an existing countertop—but there are some caveats. You’ll need to precisely measure. It’s best to choose a sink that’s the same dimensions as your existing sink, since your contractor won’t have to cut the countertop. Otherwise, pay close attention to the depth of your counter (the front to back measurement). You don’t want to install something that’s so big it sticks out beyond your countertop and cabinetry.

Countertop resurfacing or refinishing can extend the life of your countertops for an additional 5 to 10 years. The longevity depends on the quality of the materials, the amount of wear and tear, and how well the countertops are maintained. To maximize their lifespan, avoid heat damage by using hot pads or trivets, use cutting boards to prevent scratches, clean with non-abrasive cleaners, and wipe up spills promptly.

The angle at which you cut countertops depends on the material, your intended outcome, and the location of the cut. For example, rather than cutting a straight 90-degree angle for internal corners, cut edges at a 45-degree angle to give a clean, professional look. For outside edges, most homeowners want squared-off sides, so 90-degree angles can make the most sense there. Because you want to get angles exactly right to minimize seams and eliminate the need for patching, be sure to measure several times before cutting and use the right equipment to get sharp, accurate angles.