Get matched with top land clearing pros in Bishop, TX

Land surveys don’t technically expire. They do serve as a point of reference and a snapshot of your property, though, so as soon as you make changes to your property (and even if your neighbor makes certain changes to theirs), your existing land survey becomes inaccurate, and a new one must be done. Even if you don’t make any changes to your property, many states only guarantee the accuracy of a land survey for five to ten years.

A few different types of land surveys can help determine certain features and boundaries of your property. These include:

• Boundary surveys describe the actual borders of a property. These are generally required when trying to get construction permits issued. 

• Location surveys provide much of the same information as a boundary survey but also include in-depth information about any improvements made to your property. 

• Mortgage location surveys are usually required by lenders and title companies before financing or offering an insurance policy. 

• Site-planning surveys are done before applying for building permits and can be issued before any major home improvements. 

• Topographic surveys provide a formal map of land elevations. It can also describe the location and size of natural features and any land improvements.

Building a road on a slope requires careful planning and will normally require a drainage system underneath to prevent flooding and damage to the road over time. Your professional may lengthen your road to create switchbacks if the slope directly to your home is too steep, as there are regulations for maximum road slope. The drainage system will help prevent runoff from the higher side of the slope from damaging the asphalt or concrete. Keep in mind that building a road on a slope isn’t a good DIY project, as a lot can go wrong.

There are a couple of ways you can determine the depth of your well. One method is to use a device called a well sounder. This tool has a long measuring tape containing a sensor to alert you once the end reaches the water. 

Or you can DIY it by using a long tape measure with a half-filled bottle of water attached to it. Lower the tape measure into your well. Once you feel tension on the tape, you’ll know the bottle has reached your static water level. This will give you an approximate idea of your well’s depth.