Get matched with top bathtub restoration pros in Wartrace, TN

Before you begin caulking a shower, you’ll need to use a utility knife or solvent to remove the old caulk and inspect the area for mold. If needed, take appropriate steps to get rid of the mold, then wipe everything down with dish soap and warm water before letting it dry completely. Finally, surround the caulking area with two strips of blue painter’s tape—one above the joint where you’re caulking and another below it.

While tubs are fairly sturdy, you may notice cracks or holes. This kind of damage can happen from someone accidentally dropping something heavy into the tub. You might also see damage if you drop something heavy into the tub over and over again (like your extra large bottle of body wash). While you might only notice a small dent at first, this can later turn into a crack or a hole.

Also, certain cleaners that are harmful to your tub can cause damage. And if you have a fiberglass tub, you might see cracks if it was not installed properly with the right support.

Resurfacing countertops is relatively easy—especially for a pro. During this process, a countertop contractor will sand down or remove the existing countertop surface, make repairs, and then add a new surface or special coating. In certain instances, like if you use a laminate countertop coating system, it’s an attainable DIY for beginners.

Rust in your bathtub occurs when iron in the water or on metal components in your tub are exposed to oxygen, but while it’s unsightly, it won’t make bathing dangerous. However, if the rust appears under or around your tub spout or shower head, it could indicate that you have high levels of iron in your water. Drinking water with small amounts of iron in it usually doesn’t pose a health risk, but you might want to consider installing a water softener. The presence of iron could indicate that you have hard water, which can create some plumbing issues.