Get matched with top deck maintenance specialists in Oak Ridge, TN

Most building codes require that spindles or balusters on deck and stair railings be spaced no more than four inches apart. This safety standard, often called the '4-inch sphere rule,' is designed to prevent small children or pets from slipping through the railing. A good way to visualize this is that a 4-inch sphere should not be able to pass between two spindles. For the same safety reason, the space between the bottom rail and the deck floor should also be no more than four inches. As a general guideline, professionals often install three balusters per foot of railing. However, since specific requirements can vary by location, it is crucial to check your local building codes to ensure compliance before starting your project.

Pressure-treated lumber is one of the most affordable types of decking upfront. This material is widely available, so you can usually find pressure-treated lumber at almost any local home improvement store you visit. Keep in mind that wood requires a lot of upkeep with repainting and restaining, so any kind of wood may be more expensive in the long run than something like PVC decking.

The best and fastest way to remove paint from a deck often involves combining a chemical stripper with a pressure washer. Gel-based paint strippers are highly recommended because their thick consistency makes them less messy and easier to apply than liquid strippers. After applying the stripper to loosen the paint, you can use a pressure washer to efficiently wash away the residue. When using a pressure washer for this task, it's important to use a low pressure (under 1000 PSI) to avoid forcing too much moisture into the wood, which could lead to mildew or rot.

For the best results, stay off of your deck for at least 48 hours after sealing it. Giving the sealant at least two full days to cure ensures it can fully penetrate the wood, giving you the most protection from sun and weather damage later on. Walking on the deck too soon can prevent it from properly curing and cause your deck to weather prematurely.