Get matched with top sink installation pros in Plankinton, SD

A handyperson with basic plumbing experience can install a bathroom faucet, like the kind of skills you’d need to replace a P-trap or swap out a showerhead. They may not have deep knowledge of local plumbing code, though. If your faucet installation requires work on the pipes behind the wall or under the floor, hire a licensed plumber with the necessary training and licensing. 

Today’s standard sink stopper size is 1.5 inches. However, you can still find different sizes if your house uses an older sink stopper. Other sizes you can find in most hardware stores include one inch, 1-1/4 inch, 1-3/8 inch, 1-5/8 inch, 1-7/8 inch, 2 inch, 2-1/4 inch, 2-3/8 inch, and 2.5 inch.

Expect your stainless steel sink to last between 20 and 30 years on average. When well cared for, you can use your sink much longer, particularly if you protect it from rust. A new stainless steel sink costs anywhere from $200 to $1,500 including installation, so it's in your best interest to take extra care to ensure its longevity.

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.