Best roofers near Lake Andes, SD

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.

Yes, gable vents can let water in. That being said, this usually only occurs during extreme conditions like heavy rainfall. You can prevent water from entering through gable vents by adding a screen that traps the water before it can enter.

As with any roofing material, there are benefits and drawbacks to consider before installing roll roofing. On the plus side, roll roofing is budget-friendly, lightweight, and comparatively easy to install. It is also ideal for low-sloped roofs and lasts around 10 years. The cons of roll roofing, however, include its low durability compared to roofing materials, restricted color choices, and low ROI.

Pros:

• Low-cost

• Lightweight

• Cut to size

• Easy and quick installation 

• Designed for low-sloped roofs

• Waterproofs your roof for an average of 10 years

• Easy to purchase and transport

Cons:

• Less durable than asphalt shingles

• More prone to cracks and tears

• Short life span

• Not as many color or style choices

• Not as aesthetically pleasing as shingles, wood, or clay tiles

• Not preferred for a higher home resale value

The most common defect in a flat roof is leaking. Flat roofs have minimal slope, so water pools more readily on a flat roof than on a sloped roof, and the risk of the waterproof membrane failing increases with exposure. Tears and punctures from foot traffic and blown debris are other common problems, especially with single-ply roofing membranes like TPO and EPDM roofs.