Get matched with top aquarium service pros in Britton, SD

A septic tank always has some amount of liquid in it—which should usually be 8 to 12 inches from the top of the tank. If the liquid level is higher than that or is overflowing the drainage pipe that leads out to the leach field, the tank may be too full and in need of pumping.

To break down fat in a septic tank, you will need to hire a professional septic tank cleaner near you to either pump the septic tank or use a shock treatment to clear the clog. It’s important to not pour fat, oil, or grease (memorable with the helpful acronym FOG) down your drains because they can clog the septic system. Instead, you can dispose of them with regular trash, or if your household produces a lot of FOG waste, you may want to install a grease trap for your plumbing.

The bacteria already present in your septic system should be enough to break down solids in a properly maintained septic tank. However, if you’re in a DIY mood, you can try adding (well-mashed) rotten tomatoes to help the good bacteria fulfill their duty. Just make sure you give them a couple hours to work after flushing them down.

Depending on the home, wastewater either goes into a septic tank and seeps back into the backyard or is sent via sewer system to a local sewage-treatment plant. Septic systems naturally separate different components of the waste so that it can naturally and safely disperse it. They are usually reserved for homes not served by a municipal sewage department (like rural homes). A treatment plant, on the other hand, speeds up that process through screening and purification.