Get matched with top boiler installation pros in Pamplico, SC

A furnace is a big unit where gas, heating oil, or electricity heats the air. The warmed air is then pushed back out through ducts and vents. 

A boiler uses electricity, heating oil, or gas to heat water that is pushed into the room through a radiator. This is one of the oldest and most effective ways to heat a house, but radiators can also be unsightly and leave hot and cold spots in the room.

Heat pumps use a refrigerant to move heat from outside into the house and return it to the room through ducts and vents.

Hydronic and standard electric baseboard heaters differ in how they operate, their cost, and their performance. Standard convection heaters use electric coils to heat the air directly, while hydronic heaters warm a contained liquid like water or oil, which then radiates heat into the room.

In terms of cost and efficiency, hydronic heaters usually have a higher upfront price but are more energy-efficient and cheaper to run over time. This is because the heated liquid retains warmth, allowing the heater to continue providing heat for a while after the thermostat turns it off. In contrast, electric heaters provide heat more quickly but are less efficient.

Ultimately, the better choice depends on your priorities. If you need a room to heat up fast and have a lower initial budget, an electric heater might be suitable. If long-term energy savings are more important and you don't mind a slower heat-up time, a hydronic heater is likely the better option.

Most home boilers will need an expansion tank. That’s because these boilers are closed-loop systems, where the water is trapped. An expansion tank is needed when the boiler heats the water and it expands, allowing air to condense in the tank to make room for the water. Other types of boilers don’t use an expansion tank, such as traditional steam boilers, but these aren’t as common. And hot water tanks may be able to use a pressure release valve instead. When in doubt, call in a pro to take a look.

Depending on the size of your home and system, as well as any upgrades or add-ons you choose, it may take between three and five days to completely replace an existing HVAC system from start to finish. Your contractor should be able to give you an estimate before they begin the actual replacement.