Get matched with top toilet pros in Marion, SC

Some older homes have toilets in the basement to combat sewage backups. This type of toilet, also known as a Pittsburgh potty, acted as a safety valve over the incoming sewer line. If a line backed up, it would back up into the toilet because it was the lowest fixture in the home, keeping it out of sight and away from the finished areas of the house.

Basement toilets were also used by workers with messy jobs, like those who worked in coal mines or steel mills. This way, they could clean up and avoid tracking dirt through their home.

Replacing a standard toilet with an elongated one is straightforward. The two types can be installed using the same existing drainpipe and plumbing. If you have a small bathroom, make sure that an elongated toilet doesn’t violate local building codes for clearance, which is the space between fixtures and walls. 

Yes, an ambitious homeowner could decide to replace their own toilet. A person attempting to do a DIY toilet installation should keep in mind that the average toilet weighs between 100 and 120 pounds. That means that you'll need to be comfortable lifting and carrying your old toilet and replacement toilet during both phases of the project. Additionally, homeowners will need to have basic plumbing knowledge to avoid plumbing problems that could result in messy, expensive water damage in their bathrooms. Hiring a plumbing pro from the get-go can help you avoid damaging your plumbing or your new toilet.

The cost to install a new toilet typically runs from $225 to $530. This doesn’t include the price of the toilet itself, which can cost $90 to $1,500 depending on the model and features you choose. You can save money if you choose to install a toilet yourself. However, you might want to hire a pro for this project.

"Due to the many complexities of replacing a toilet flange, it is typically a job best left to the pros," says Jeff Botelho, Angi Expert Review Board member and plumber. "Many times it isn't as simple and straightforward as 'pop off the old one and pop on a new one' because the flange is either glued on (PVC/ABS), soldered on (brass/copper), or caulked in place with a lead & oakum joint (cast iron) and none of these things can be easily reversed without years of training and repetitive practice."