Get matched with top stucco pros in Estill, SC

You can use small bits that are up to 3/8 inch in diameter, or larger bits that are 1/2 inch or more in diameter. Make sure the bits you use are coated with carbide or diamond; this information is usually visible on the package. You can also use hole saw bits to drill into stucco.

The decision to repair or replace stucco depends on the extent of the damage. For minor issues like small cracks, holes, dirt, stains, or discoloration, a repair is typically sufficient and more cost-effective. These issues can often be resolved with a simple repair, a deep clean, and possibly a new coat of paint. However, for more significant problems such as large cracks, peeling, mold, algae, or structural water damage, a replacement might be necessary. In these cases, it is best to call a professional stucco contractor for an inspection. An expert can assess the severity of the damage, determine if there are deeper issues, and advise whether a repair is adequate or if replacing a section or an entire wall is the more cost-effective, long-term solution.

Yes, you can apply the stucco yourself, but it is a time- and labor-intensive project, especially on the exterior of a whole house. DIY stucco is better suited for repairing stucco siding or siding a smaller building, such as a shed or garage. Since most of the cost of stucco siding goes to labor, you can cut down significantly on the total if you’re up for the challenge.

To maintain stucco, inspect it annually for cracks and clean the surface with a mild detergent. Seal any cracks promptly to prevent water infiltration, and reseal or repaint as needed to preserve its appearance.