Top-rated deck maintenance specialists.

Get matched with top deck maintenance specialists in Thompsontown, PA

Enter your zip and get matched with up to 5 pros

Need a pro for your deck maintenance project in Thompsontown, PA?

Select your specific project to find the pro for you.

Find Deck maintenance specialists in Thompsontown

Avatar for Harmon's Handyman
Harmon's Handyman
4.9(
8
)
Deck, Fence, Patio or Porch - Clean and Seal

Serving Thompsontown, PA and surrounding areas

Approved

Free estimates

"Very impressed with the quick response and efficient job!! My spouting and down pipes were completely blocked. Jordan evaluated the problems and explained each step that needed to be done. Excellent work!!"
Soffit/fascia repair
Soffit/fascia repair
Pressure washing
Pressure washing
 exterior door trim

+3

4 neighbors recently requested a quote
Showing 1-10 of 35
Deck Maintenance questions, answered by experts

In many areas, a floating deck that isn’t connected to your home and stays under 200 square feet and below 30 inches in height may not need a permit. These freestanding structures are often considered low-risk, which can simplify the building process. However, building codes vary greatly based on location. Before investing in any home improvement project, check with your local permitting office for deck-building guidelines.

Deck boards should be spaced no more than three-eighths of an inch apart. This is enough space to allow water and small debris to pass through without collecting on the surface, but not enough to create a tripping hazard. Certain materials, like pressure-treated wood, shrink over time, so they may need less space at installation.

Spindles on a deck may also be called balusters or pickets. While not as important to the structural support of the deck as the rail posts, they play a critical role in ensuring the deck is safe to use by closing in large gaps in the railing. For this reason, balusters must be no more than 4 inches away from one another.

Yes, Ipe is more expensive than Trex decking—both in terms of materials and installation (plus, Ipe trees are endangered). On average, Ipe decking costs $10 to $25 per square foot, while Trex decking costs $5 to $12 per square foot. Because Ipe is harder to work with, the price of installation is higher, too. For Ipe decking, you’ll pay between $20 and $45 per square foot for labor. However, with Trex decking, the labor costs range from $8 to $22 per square foot.

The overhang, or nosing, of deck steps is another area that will be covered in building code requirements. The noses on your deck steps should have a minimum overhang of ¾ inch. For safety, usability, and code compliance, the nosing of deck steps should not extend past 1¼ inches.

The Thompsontown, PA homeowners’ guide to deck maintenance services

From average costs to expert advice, get all the answers you need to get your job done.