Top-rated deck cleaning pros.

Best deck cleaning pros near Thompsontown, PA

Enter your zip and get matched with up to 5 pros

Need a pro for your deck cleaning project in Thompsontown, PA?

Select your specific project to find the pro for you.

Top-Rated Deck cleaning pros in Thompsontown - Updated Nov 2026

Avatar for Harmon's Handyman
Harmon's Handyman
4.9(
10
)
Deck, Fence, Patio or Porch - Clean and Seal

Serving Thompsontown, PA and surrounding areas

Approved

Free estimates

"Very impressed with the quick response and efficient job!! My spouting and down pipes were completely blocked. Jordan evaluated the problems and explained each step that needed to be done. Excellent work!!"
Soffit/fascia repair
Soffit/fascia repair
Pressure washing
Pressure washing
 exterior door trim

+3

6 neighbors recently requested a quote
Showing 1-10 of 35
Deck Cleaning FAQs, answered by experts

The cost to repair a deck is between $900 and $3,500, depending on the cause and extent of the damage. For example, fixing a sinking deck caused by pest damage can cost between $200 and $600, while replacing sinking boards costs between $500 and $4,000.

The best way to sand a deck is by cleaning it, sanding the boards and stairs with 60- or 80-grit sandpaper, and sanding the railings and posts with 80-grit sandpaper. You should sand in the direction of the wood grain to avoid damaging the timber. When sanding your deck, use medium pressure and aim for an even sand. Pressing too hard with a sander can damage decks, as most are softwoods.

Materials for a second-story deck must be weather- and rot-resistant, though the specific choices will largely be determined by your budget and style preference. Pressure-treated wood is on the lower end of the price scale, but it can be customized and stained the way you like it. Composite, on the other hand, is pricier for installation and has fewer options for customization, but you’ll save money and time in the long run because it requires little maintenance.

Yes, deck pier blocks can be used as an alternative to traditional deck footings, particularly for small or low-to-the-ground decks. Unlike poured concrete and buried post footings, deck blocks don’t require digging or pouring. However, their use is regulated by local building codes, and they may not be permitted in areas prone to high winds, earthquakes, or hurricanes. Always consult your local building codes before choosing them for your deck project.

There are approximately 5.33 board feet in a 2x4. You can use the board foot calculator in this article to easily find the answer. A 2x4 is 2 inches of thickness by 4 inches of width, so you need to find the length, with 8 feet being the most common. You’d use the calculator here to multiply 2 times 4 times 8, and then divide by 12, arriving at a total of 5.33 board feet. 

The Thompsontown, PA homeowners’ guide to deck cleaning services

From average costs to expert advice, get all the answers you need to get your job done.