Get matched with top electricians in Larksville, PA

Most electric water heaters have a built-in shut-off switch, so you can simply turn that to the OFF position. Some water heaters have the switch inside a panel, so you might need to unscrew the panel, remove it, move aside the insulation, and then shut the water heater off. To make sure it’s off, you can also locate the switch for your water heater in your electrical panel and shut the power off there. Most electrical panels have dedicated switches for the water heater, so you can shut off the power without affecting the rest of your home.

Yes, electricians must be licensed, certified, and in most cases, insured. Licensing requirements vary by state and local municipality, but most U.S. municipalities require electricians to hold an electrical contractor’s license. It's always a good practice to confirm requirements with your local municipality. Even if licensing is not required in your area, hiring a licensed and experienced electrician often leads to a better end result.

A license is a legal requirement to operate a business and is necessary for pulling project permits. Certifications, on the other hand, are typically voluntary and demonstrate a certain level of expertise. In some cases, a certified electrician may send an apprentice or journeyman to perform the work, but they must operate under a primary electrician who holds the proper license.

Before hiring, you should verify the electrician's license, insurance coverage, and any third-party certifications. You can use Angi’s contractor licensing search to confirm a pro's license status. Additionally, businesses with the “Angi Approved” badge on our platform meet strict criteria, including having the required state and local licenses, passing a background check, and maintaining a high average rating.

A larger heater requires a larger breaker—unless there’s one already installed. The longer answer to this question is more nuanced. Do you place demands on the heater at the same time as running other heavy-duty appliances like ovens and washing machines? Do you live in an older home that may not have considered the higher electrical demands we have now? Breakers need to be sized at 125% of the load. To find that load, you should call a local electrical pro.

If you’re moving wires, installing new wires, or installing new fixtures in the space you’re insulating, then you will need to hire a licensed electrician to do that portion of the job for you. However, if you just intend on replacing old insulation or adding new insulation over existing insulation, then you don’t need to hire one. Your insulation installer will work around wiring, fixtures, outlets, and switches, even if they’re installing fiberglass batts in the voids where wires run. However, you will need an electrician if you suspect a problem with your wiring during the insulation work.