Top-rated stucco pros.

Get matched with top stucco pros in Wallowa, OR

Enter your zip and get matched with up to 5 pros

Need a pro for your stucco service project in Wallowa, OR?

Select your specific project to find the pro for you.

Find Stucco pros in Wallowa

Avatar for JBC Group Solutions Inc
JBC Group Solutions Inc
4.0(
4
)
Synthetic Stucco - Install or Completely ReplaceSynthetic Stucco - Install or Completely Replace- For BusinessSynthetic Stucco - Repair or Partially Replace- For Business+4 more

Serving Wallowa, OR and surrounding areas

In business since 2007

Emergency services offered

"I have been using them for 3 years for multiple projects and would not go to somebody else. They also built a cabin in the woods. It was built 10 miles from the road so it was like carrying all the stuff up the path. They also did the garage and remodeling of the house, mostly kitchen and a little bit of plumbing work in the bathroom. I am still using them and I would be using them for the next thing that will be coming up too."
Custom Staircases
Custom Exterior Restoration
Custom Bathrooms
Recommended by75%of homeowners
Stucco questions, answered by experts

Stucco will dry in two to three days, but you should wait one to two months to allow it to cure fully before you paint it. The curing process is slow, but leaving the material exposed to air and natural moisture will help it reach its maximum strength. If you live in a hot, arid climate, wait a month before painting. Wait two months before painting if you live in a more moderate or wet climate.

Cracks in the chimney can be very serious, depending on their location and size. Even small cracks can become serious over time if left unrepaired. Cracks allow heat and moisture to deteriorate your chimney and harmful carbon monoxide gas to seep into your home. Small cracks can often be caulked, while large cracked sections may require full replacement.

A standard drill will work just fine if you’re drilling small holes, and only a few of them. But anything with a diameter larger than 3/8 inch is best done with a hammer drill, since it is stronger, faster, and also makes your drill bits last longer. While you don’t absolutely need a hammer drill for stucco, it is a worthy investment if you think you might drill more holes down the road.

If contractors discover water damage, rot, or mold beneath the stucco, additional repairs will be necessary. These repairs can increase your total project cost and timeline, but addressing them promptly is essential for your home’s structural integrity. Ignoring hidden damage can lead to more severe issues and higher costs in the future.

Yes, you can screw directly into stucco. Only do so if the item you are installing is a permanent fixture. Drill a pilot hole into the stucco using a masonry or concrete bit, then drive in the screw with a power drill or screwdriver.

The Wallowa, OR homeowners’ guide to stucco services

From average costs to expert advice, get all the answers you need to get your job done.