Get matched with top electricians in Salina, OK

Unless you’re a licensed electrician, you should not DIY any electrical work in your home. Working with wires and electricity is potentially dangerous to both you and the structure you’re working on, and it could lead to house fires or electric shock if you’re not 100% sure what you’re doing. There’s a big difference between changing a light switch cover and rewiring an entire home. If you’re staring down a potentially difficult electrical job, give a pro a call.

To prevent a plug from overheating, always ensure that the electrical load connected to the plug does not exceed the plug's capacity. If the plug feels hot to the touch or emits a burning smell, immediately shut off the circuit breaker and unplug all devices from the hot outlet. Prevent electrical fires by avoiding using extension cords or adapters with the plug, as they can cause it to overheat due to increased resistance. Additionally, ensure that the plug is properly inserted into the outlet and that the outlet is not damaged or loose. 

The National Fire Protection Association reports that almost half of reported electrical fires are caused by electrical distribution and lighting equipment. The main culprit behind these fires is often frayed, worn, or faulty wiring, particularly in closed-off and concealed areas like attics, where fires can start and burn undetected for long periods.

No, you should never plug a generator directly into a wall outlet in your house. This practice is extremely dangerous, often illegal, and can cause "back-feeding," where power from the generator flows back into utility lines, creating a life-threatening hazard for utility workers. It can also damage your home's electrical system, including appliances like pumps and HVAC fans. If the main power is restored while the generator is connected, it can destroy the generator and cause an electrical fire. To safely connect a generator, you must use a professionally installed transfer switch or an interlocking kit, which prevents back-feeding by disconnecting your home from the utility grid before the generator provides power.