Get matched with top roofers in Mooreland, OK

You’re going to need a permit for nearly every roof-raising project. This is a very important step, as the work you’re doing has serious safety considerations. Professionals are the ones to handle this type of work—including sourcing the permits—as they have the expertise required to perform the work safely. Insurance and warranty are usually voided if you do this work without a permit, and you may even be required to halt construction and tear it down as a penalty for working without a building permit.

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.

Yes, removing a chimney is a difficult and major undertaking. Chimneys often provide structural support to a home, so if it's a load-bearing structure, you'll need to take extra precautions to maintain your home's integrity. A project of this complexity typically requires a structural engineer, a masonry contractor, and a demolition crew. The removal process may involve taking the chimney out brick by brick from inside the walls. The cost for chimney removal can range from $2,000 to $10,000, depending on the job's complexity. Due to the difficulty and cost, some homeowners opt to remove the fireplace and seal the chimney at the top and bottom, sometimes also removing the visible exterior portion at the roofline.

Asphalt shingles, wooden shakes, and slate or clay roofing tiles are often replaceable without having to replace the entire roof. It's possible to replace just a few shingles or tiles without much trouble in the case of wind damage or other minor problems. DIYers can perform the task in some situations. However, professional repair is always the best bet when it comes to roofing.