Get matched with top fire pit installation pros in North Jackson, OH

No, it is not safe to use an outlet that sparked. A spark from an outlet could indicate a short circuit, loose or frayed wiring, or other serious damage. Continuing to use an outlet that sparks can increase the risk of electrical shock, electrical fires, and other hazards. It's important to turn off the power to the outlet at the circuit breaker if possible and avoid using the outlet until a licensed electrician has inspected and repaired it.

You can let a fire burn out in a fireplace as long as you or someone else will stick around to monitor it until it goes completely out. This may take several hours. To prepare, stop adding fuel to the fire well before you’re ready to call it a night. If you’re using the fireplace for warmth, you’ll want to cover up in some blankets as the flame dies down.

The National Fire Protection Association (NFPA) says you can place smoke detectors on either the ceiling or the wall, depending on the setup of your room. Since smoke rises, the ceiling makes sense, but if you go with a wall mounting, the alarm should be installed high up—no less than 12 inches from the ceiling. 

You should not attempt to disable a smoke alarm unless you’ve already activated a replacement unit. To stop a hardwired smoke alarm from beeping, reset the device or silence the alarm. If you’re removing a hardwired alarm, shut off the power, turn the unit counterclockwise to remove it from the ceiling, and disconnect the wiring.