Top-rated drywall insulation pros.

Best drywall insulation pros near Lakemore, OH

Enter your zip and get matched with up to 5 pros

Need a pro for your drywall insulation project in Lakemore, OH?

Select your specific project to find the pro for you.

TRUSTED BY LAKEMORE, OH HOMEOWNERS

  • Average homeowner rating star icon4.6
    Average homeowner rating
  • Verified reviews icon209
    Verified drywall insulation services reviews

Top-Rated Drywall insulation pros in Lakemore - Updated Nov 2026

Avatar for ***** INSTALLED SERVICES INC ***** (440)-339-7023
***** INSTALLED SERVICES INC ***** (440)-339-7023
5.0(
87
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Lakemore, OH and surrounding areas

Approved

In business since 2006

Free estimates

Emergency services offered

"Our large church / school facility required insulation upgrades due to high utility costs and severe gutter icing. We chose Installed Services due to their favorable bid, ability to provide knowledgeable explanation of our insulation issues, and responsiveness to questions / communications. Work was completed in a timely manner. We would likely hire them again if we need further services in the future."
Additional Photos
Additional Photos
Additional Photos
3 neighbors recently requested a quote
Recommended by98%of homeowners
Avatar for Unified Insulation Systems, LLC
Unified Insulation Systems, LLC
4.9(
82
)
Blown-In Insulation - Install or Upgrade

Serving Lakemore, OH and surrounding areas

Approved

In business since 1999

Free estimates

Warranties offered

"The work was done well and with great care for our siding and the inside wall where the insulation was blown in. Clean up was immaculate. Installers were friendly and courteous. We would highly recommend them."
Home Comfort Crew
Response time1 day
Response rate88%
5 neighbors recently requested a quote
Avatar for Primary Home Improvements
Primary Home Improvements
5.0(
27
)
Blown-In Insulation - Install or Upgrade

Serving Lakemore, OH and surrounding areas

Approved

In business since 2021

Free estimates

Warranties offered

"I liked these guys from start to finish. Very friendly, did a great job, and cleaned up after themselves. Didn’t try to add a bunch of extra projects and expenses like other insulation contractors I spoke with. Came in with the cheapest quote too. Insulated my attic and one room."
RetroFoam Injection Foam Insulation
RetroFoam Injection Foam Insulation
Primary Home Improvements Insulation Crew
Primary Home Improvements Insulation Crew
Primary Home Improvements Insulation Crew

+3

Response time10 hrs
Response rate88%
16 neighbors recently requested a quote
Avatar for USA Insulation of Akron
USA Insulation of Akron
3.8(
68
)
Blown-In Insulation - Install or UpgradeInjection Insulation - Install

Serving Lakemore, OH and surrounding areas

Approved

In business since 1977

Free estimates

Credit card accepted

"The sales rep was very knowledgeable about what I needed. Even though I was asking for a very expensive install, the rep knew that what I wanted was overkill and I didn't know what I was asking for. He explained very courteously that I needed something less. The installers were quick and also courteous. I liked working with USA Insulation and would hire them again."
Outside
Bedroom
Spraying
Response time2 days
Response rate93%
34 neighbors recently requested a quote
Avatar for PURE SEAL INC
PURE SEAL INC
4.7(
27
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Lakemore, OH and surrounding areas

In business since 2004

Credit card accepted

"

Torsten Hansen has the patience of a saint.  As I was considering my options with other companies, I bombarded him with a multitude of questions which he answered thoroughly and in a timely manner.

His price was the best.  



 I have one complaint.  I have a bedroom above an unheated garage.  We removed the old drywall and fiberglass insulation which was riddled with squirrel mess.  We also added air conditioning to the house.  There are heating/air conditioning ducts running at the side of one garage wall and across 3 areas of the garage ceiling. The HVAC contractor said to make sure those were well insulated or humid air would condense on the ducts and damage the new drywall.  I thought that foam would be the best option.

Pure Seal did a really good job of insulating the side vents with high density foam. I had the ceilings and walls done in medium density foam.  But, they left the bottom halves of the ducts across the ceiling unfoamed.  In all but a few spots there was a good 2 inches or more space from the bottom of the vent to the end of the joist.  I measured it . Torsten went out and looked at it from the ground and said there was nothing they could do.  He said if I was worried about condensing water dripping onto the underside of the drywall when the air was on, I could staple some plastic over the areas.  Not a good solution.

 

I tried to foam the vents myself with Great Stuff, but it would not stick to the horizontal surface of the ceiling ducts.  It kept falling off.  So I wound up ripping the vapor barrier off of some fiberglass insulation and tapping it up in the cavity below the ceiling vents.  I then covered the fiberglass with reflectix stapled to the joists.  I told Torsten what I did and he thanked me for taking care of it but stuck by his decision that they could not have done anything.

 

I was disappointed because this was one of the main reasons I wanted foam. 

 



They also cut a wire in trimming the foam but he did offer to pay to fix that. My electrician was doing something else for us so he did not charge us.  That kind of stuff happens and I would not fault him for that but they should have caught it when they inspected their job instead of me having to tell them about it.


"
Applying Spray Foam
Pumping Air Krete
Finishing the Job
Recommended by91%of homeowners
Avatar for A & J Insulation Inc
A & J Insulation Inc
4.7(
260
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Lakemore, OH and surrounding areas

In business since 1977

Free estimates

Credit card accepted

"We scheduled to have an estimate done for insulating our house due to the drafts in our house. The man doing the estimate was on time and professional. and more importantly was honest and told us our house was insulated adequately. There were a few spots above the windows that were lacking insulation. He told us we could spend money to fill those few spots but it wasn't a big problem. We appreciated his honesty and not looking to make a quick buck.
"
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+11

Recommended by96%of homeowners
Showing 1-10 of 49
Drywall Insulation FAQs, answered by experts

A post-drywall inspection could uncover many problems that weren’t present during the pre-drywall inspection, including insufficient insulation, missing weather stripping, improperly installed plumbing and lighting fixtures, flooring damage, drywall damage, plumbing leaks, aesthetic issues, and more. Structural problems, which are often expensive to fix and are common reasons to walk away after a home inspection, are easier to see before the drywall goes up, but a post-drywall inspection may highlight minor issues with house settling and foundation problems.

Mudding drywall is a DIY-friendly project, but patience and practice are required for perfection. If you’re working in a highly visible area and want the best possible finish, hiring a professional drywaller is worth the cost. Pros have the tools and know-how to ensure a smooth surface with fewer sanding sessions and less cleanup.

Whether it’s better to screw or glue drywall depends on your specific budget and project timeline. Professional drywall installers are more likely to use screws and fasteners than adhesives, but it takes longer. But if you are DIYing your drywall installation, glue is a perfectly fine choice if you’re willing to pay extra for adhesive.

You should wait at least 24 hours for drywall mud to dry before sanding or applying another coat. However, the exact drying time depends on several factors, including the thickness of the application, room temperature, humidity, and the type of compound used. Thicker layers, or projects in high humidity, may require 48 hours or more. Lightweight compounds tend to dry faster than heavier, all-purpose ones. You'll know the mud is ready when it feels completely dry and firm to the touch and has changed to a consistent light color. Sanding too early can cause smudging or gouges, so patience is essential for a smooth finish.

You can usually tell if you have plaster or drywall by touch (plaster is harder, colder, and smoother than drywall) or by tapping on it (drywall sounds hollow, plaster does not). If you still cannot tell, peek under an outlet cover and check the cut edges. The rough edges show the composition of the wall. You will see either drywall (two paper sheets sandwiching gypsum material) or only plaster material (no paper sheets).

The Lakemore, OH homeowners’ guide to drywall insulation services

From average costs to expert advice, get all the answers you need to get your job done.