Get matched with top above ground pool installation pros in Creston, OH

Yes, pool pumps use a significant amount of electricity, making them one of the biggest energy consumers in a home. A pool pump can use up to three times as much electricity as a refrigerator. Typically, a residential pool pump consumes about 1 kilowatt-hour (kWh) for every hour it runs. Because pumps often need to run for about eight hours a day to properly filter the water, this can add up to an annual consumption of 3,000 to 5,000 kWh, which can cost between $480 and $800 per year based on average electricity rates.

The amount of electricity your pump uses depends on its size, energy efficiency, and daily run time. To lower your energy consumption, you can choose an energy-efficient or variable-speed pump, ensure it is correctly sized for your pool, and run it only for the minimum time required to keep the water clean.

There are pros and cons of in-ground vs. above-ground pools, which you should consider when choosing the pool of your summertime dreams. Some factors to think about include: 

• Above-ground pools are semi-permanent and movable, whereas in-ground pools are permanent structures.

• In-ground pools are more expensive to install than above-ground pools. 

• It takes one to three days to install above-ground pools and several weeks for an in-ground pool install.

• You can install an above-ground pool in smaller yards, but you need plenty of space for an in-ground pool.

No, you should not use an extension cord with an aboveground pool pump. In addition to being dangerous as a tripping hazard, use of an extension cord could void your pool pump’s warranty. This is because using an extension cord not rated for use with the pool filter pump could damage this equipment.

In combination with adequate filtering and water chemical balance, vacuuming will keep your pool from being overrun with algae. If your pool is experiencing algae growth, the same combination will get rid of it with a bit of patience. Heavy algae growth may require the use of an algaecide, and in some cases, you’ll want to vacuum the pool 24 to 48 hours after using algaecide to remove dead algae debris.