Best above ground pool installation pros near Brewster, OH

The number of gallons in your pool will determine how much chlorine you’ll need to add to your pool for the first time. Chlorine levels should fall between 1 and 3 ppm. It's crucial to read the instructions on your chlorine packet to determine the number of tablets to put in the water based on your pool's capacity.

You don’t need to drain the whole pool to patch a pool liner, but be prepared to dive in with your swimsuit and goggles to patch a leak below the water level. By draining the pool, you can actually expose the liner to more harsh conditions, like wind and sunlight, that cause the tears to worsen. It’s best to use the ink test and waterproof patches or tape to identify the leak and patch it up.

Yes, pool pumps use a significant amount of electricity, making them one of the biggest energy consumers in a home. A pool pump can use up to three times as much electricity as a refrigerator. Typically, a residential pool pump consumes about 1 kilowatt-hour (kWh) for every hour it runs. Because pumps often need to run for about eight hours a day to properly filter the water, this can add up to an annual consumption of 3,000 to 5,000 kWh, which can cost between $480 and $800 per year based on average electricity rates.

The amount of electricity your pump uses depends on its size, energy efficiency, and daily run time. To lower your energy consumption, you can choose an energy-efficient or variable-speed pump, ensure it is correctly sized for your pool, and run it only for the minimum time required to keep the water clean.

Shipping container pools are prone to rust and corrosion over time, especially if you install a saltwater system. Though the interior of your pool should be lined, the outside is at risk. Luckily there are a few things you can do.

Elevate your pool or place it on a foundation to prevent moisture buildup along the bottom of the container. Apply a rust inhibitor or paint to protect the outside of your pool, and maintain the proper chlorine levels to reduce the rate of corrosion. Regularly inspect your pool for signs of corrosion, and take action when necessary.