Get matched with top roofers in Owasco, NY

Roofers don’t typically replace vent pipes themselves, but they do handle the flashing and seals around vent pipes when working on a roof. During a roof replacement or repair, roofers inspect the vent pipe flashing for damage, replace deteriorated seals, and ensure the pipe is properly integrated into the roofing system to prevent leaks. If the vent pipe itself is cracked or damaged, a plumber is usually required to replace it, while the roofer ensures the roofing components around the pipe remain watertight.

Metal roofs have a bad reputation for being loud, even if that's not necessarily true—it's usually only thin tin or sheet metal roofs that are loud during storms. Stone coating adds a layer to the metal that severely cuts down on any noise from rain. In many ways, stone-coated steel roofs are quieter than your average, run-of-the-mill asphalt shingle roof.

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.

It’s possible for a roofing estimate to change after the initial assessment, but in most cases, it shouldn’t. There’s always the risk that something unexpected will happen that causes prices to go up, like discontinued materials or your roofer discovering previously hidden damage to your decking when ripping off the old roof. However, experienced roofers should account for these circumstances in their initial estimates. Roofing contracts are binding, so always check your contract for language about how and why your numbers could change.