Get matched with top pool table assembly pros in Marcellus, NY

Yes, you should keep your pool pump running when adding salt, and leave it running for 24 to 48 hours. This will help circulate the salt to ensure even distribution. You will want to turn off your pool’s salt chlorine generator before adding salt and leave it off until it fully dissolves. Check your manufacturer’s instructions for steps specific to your saltwater pool maintenance.

In combination with adequate filtering and water chemical balance, vacuuming will keep your pool from being overrun with algae. If your pool is experiencing algae growth, the same combination will get rid of it with a bit of patience. Heavy algae growth may require the use of an algaecide, and in some cases, you’ll want to vacuum the pool 24 to 48 hours after using algaecide to remove dead algae debris.

Yes, adding a pool to your property will almost always increase your homeowners insurance premiums. This is because pools are considered a greater liability due to their potentially hazardous nature, and the added replacement cost of the pool is factored into your home's rebuilding cost when considering coverage limits. The amount of the increase can range from as little as $50 to a few hundred dollars more per year, depending on your insurance provider, location, current coverage, and the safety features installed. Before building a pool, it is highly recommended to contact your insurance agent to get an estimate, discuss their specific guidelines and requirements, and factor the increased premium into your total pool installation costs.

Yes, pool pumps use a significant amount of electricity, making them one of the biggest energy consumers in a home. A pool pump can use up to three times as much electricity as a refrigerator. Typically, a residential pool pump consumes about 1 kilowatt-hour (kWh) for every hour it runs. Because pumps often need to run for about eight hours a day to properly filter the water, this can add up to an annual consumption of 3,000 to 5,000 kWh, which can cost between $480 and $800 per year based on average electricity rates.

The amount of electricity your pump uses depends on its size, energy efficiency, and daily run time. To lower your energy consumption, you can choose an energy-efficient or variable-speed pump, ensure it is correctly sized for your pool, and run it only for the minimum time required to keep the water clean.