Get matched with top toilet pros in Pioche, NV

Adding another bathroom isn’t the most complicated project you can undertake, but it’s in the top 5%. Anything involving plumbing and electrical work should be handed off to a pro, and adding a half bath involves both. A contractor may charge $70 to $120 an hour for labor, but chances are they can work much faster and more accurately than a DIYer.

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

Yes, you can clean a toilet tank with white vinegar. Before you do, shut off the water supply to the toilet. Then, flush it to empty the tank. Next, combine one part vinegar with one part water in a spray bottle and spray the mixture inside the tank. Let it sit for 10 minutes, then rinse away the vinegar by pouring clean water into the tank. Make sure the tank is empty, then dip a scrub brush in vinegar and clean the tank’s inside walls. Turn the water back on and flush again to rinse away the vinegar.

Yes, you can pour water down the toilet to help it flush. For each flush, you’ll need 1 to 2 gallons of water for newer toilets or 3 to 5 gallons of water for older toilets. Rather than dumping the entire bucket in all at once, pour the water in slowly for the best results. If you’re pouring water down the toilet to help it flush after a clog, only use 1 gallon of hot water.