Get matched with top floor polishers in Mesquite, NV

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.

You can buff out small scratches or indentations from your hardwood floor, but refinishing is your best bet if you have larger areas that need work. Floors in relatively good shape but have lost their luster can be restored with thorough buffing. If your finish has worn off in areas or if you have sun or water damage, you should go with refinishing instead.

Most DIY floor cleaners don’t require rinsing, but you’ll want to make sure you don’t add too much dish soap or oil to the cleaner to avoid having to rinse it after cleaning. For non-wood floors, mix 8 parts warm water, 1 part vinegar, and 1 part baking soda with a few drops of dish soap. For wood floors, use olive oil in that same mixture instead of the vinegar. You can let these solutions air-dry after cleaning your floors with them, although you should manually dry your floors if they aren’t waterproof.

To properly maintain and care for hardwood floors without damaging the finish, establish a regular cleaning routine. Sweep with a broom or microfiber dust mop daily, or vacuum weekly, to remove dirt and debris that can scratch the surface; be sure to clean in tight corners and under furniture. For a deeper clean, use a damp mop with a cleaner specifically designed for hardwood floors, but avoid using harsh chemicals or excessive water, as this can damage the wood. You can further protect your floors by placing mats at entryways to catch dirt and moisture and putting felt pads under furniture legs to prevent scratches. For long-term care, refinish the floors as needed to keep them looking their best.