Top-rated floor cleaners and waxers.

Get matched with top floor cleaners and waxers in Quay County, NM

Enter your zip and get matched with up to 5 pros

Need a pro for your floor cleaning and waxing project in Quay County, NM?

Select your specific project to find the pro for you.

Find Floor cleaners and waxers in Quay County

Avatar for E & E Santa Fe Cleaning Service
E & E Santa Fe Cleaning Service
4.7(
506
)

Serving Quay County, NM and surrounding areas

In business since 2012

Free estimates

Emergency services offered

"Three ladies came to my home and cleaned every single surface, doors, frames, baseboards, floors, the kitchen and bath in 6 1/2 hours total. They did an excellent job and got a few tough areas I had not been able to get completely clean. I clean very well, but didn't want to spend the time to do the whole house at this time. Usually cleaning services do not clean as well as I do, but E & E did a better job than I do myself. It was a bit pricey, but they did such an incredible job I cannot really complain about the cost."
Additional Photos
Additional Photos
Additional Photos
Recommended by92%of homeowners
Kristin's Kleaning
New to Angi

Serving Quay County, NM and surrounding areas

In business since 2019

Free estimates

Credit card accepted

With years of experience serving the area, we are your solution for all your Cleaning needs. We take great pride in our extreme professionalism, timeliness and superior customer service on every job. We make sure to develop a lasting relationship so that the next time service is needed there will be no question on who to call. Check out our 5 star reviews from happy customers! Call us today so we can discuss your needs and make a plan that fits your budget. Satisfaction guaranteed!

LS Solutions
3.7(
8
)

Serving Quay County, NM and surrounding areas

In business since 2016

Free estimates

Emergency services offered

"Leon is the best!! In my six years of property management I've never seen an apartment so dirty and demolished. Leon came the next day and worked endlessly until the job was done. Him and his team were very polite and friendly. (Despite the horror inside) They took out all of the trash, broken fixtures, and even the carpet. And then cleaned the whole apartment!! I would recommend his company to anyone."
After An Hour Of Starting
Hallway
:/
Kitchen
Master

+20

Response time12 hrs
Recommended by83%of homeowners
Floor Cleaning and Waxing questions, answered by experts

Yes, you can mop hardwood floors with a damp flat or string mop as long as it is not soaking wet. Always avoid leaving standing water or fully soaking your hardwood floors, even if they are properly finished. A slightly wet mop, with or without cleaning solutions, will not damage the wood.

Most experts agree that the best thing with which to clean epoxy floors is a diluted mixture of ammonia and warm water. You can also use mild dish soap diluted with warm water or a degreaser (such as Simple Green or Goof Off) diluted with warm water. Some soap-based cleaners can leave a haze. If you notice this, further dilute the mixture with water or use a different detergent that does not leave a film. You should never use harsh cleaning chemicals, any type of acidic compound (such as vinegar or citrus-based cleansers), or harsh scrubbers like steel wool or hard bristle brushes.

Yes, but with caution. A floor grinder is intended to level and polish concrete, so it is a very powerful tool. To remove paint, the floor grinder should be set to 35 square feet per minute or less to minimize the pressure without the use of pocket weights. You might need to go over the surface two times to get any paint that has sunk into the concrete’s pores.

Before starting on a full refinishing project, determine if your floors need to be completely sanded down to the bare wood or if the damage is shallow and mostly cosmetic. Deep scratches and gouges will require you to rough sand using a drum sander or belt sander, but small surface scratches or floors that have only lost their luster don’t need a complete overhaul. Instead, you can skip the rough sanding step and sand-screen the old finish with a buffer, removing only the top layer of polyurethane.

After carpet removal, prepare for new flooring by assessing the subfloor. You will want to address any imperfections to create a smooth and level base for installation. Remember, proper subfloor preparation is crucial for optimal new flooring results. Consider repairing and replacing damaged areas for a stable foundation. For both wood and concrete subfloors, consider sanding to remove any debris or adhesives remaining thoroughly. 

The Quay County, NM homeowners’ guide to floor cleaning and waxing services

From average costs to expert advice, get all the answers you need to get your job done.

What do you need done? We’ll find top pros.
  • 🌱 "Mow a small front yard"
  • 🛠 "Fix a leaking pipe under the sink"
  • 🏠 "Repair shingles on an asphalt roof"