Get matched with top well and pump technicians in Pecos, NM

Most well pump pressure switches have a factory setting of 30 to 50 PSI. There’s some flexibility with this if you’d like a lower or higher water pressure, but remember that it should sit 2 to 3 PSI above your well tank’s general pressure setting.

The inside of your pressure switch cover will usually indicate minimum and maximum settings—going below and above the numbers might damage your well pump.

Though sprinkler systems can have varying issues, there are a few common ways to know if the cause is your pump. Signs include cracking or visible damage, leaking from the pump, a pump that won’t turn on, and loud noises coming from your pump. Low or irregular pressure could also point to a pump problem, but there are other causes.

Frozen well pipes make themselves known quickly, as your faucets slow down to a trickle or shut down completely. If you notice a serious reduction in flow in the winter from toilets, showers, kitchen faucets, and other plumbing fixtures, a frozen pipe or two is to blame. Another tell-tale sign is frost or ice on exposed pipes outside. 

No, a larger well pressure tank will not increase or improve water pressure on its own. The pressure control on the well pump is what determines the water pressure in your home. However, a larger tank does offer other benefits. It can hold more water, allowing you to run it for longer before the pump needs to turn on. Because the pump cycles on and off less frequently, there is less stress and wear on the well system. This can lead to a longer lifespan for the pump and tank, and you may experience fewer pump-related issues that could affect your water pressure in the long run.

If you want to increase your water pressure, you can try one of the following solutions:

• Adjust the tank’s pressure settings to a higher PSI (pounds per square inch).

• Replace your current pump with one that has a higher flow rate (GPM).

• Install a water pressure booster pump in your plumbing system.

• For pressure fluctuations, consider replacing your current setup with a constant pressure system.