Get matched with top pressure washers in La Luz, NM

Your deck may look or feel fuzzy after pressure washing because the high-pressure spray tears some wood fibers as it removes the outer layer of dead and discolored wood. This fuzzy effect is a normal part of the pressure-washing process and will go away on its own in a few weeks. You can opt to spot-sand your deck if you’d like to remove it more quickly.

This process doesn’t necessarily require soap or detergent, but it definitely helps. You can get by with just using water, but remember, brick requires a lower-than-average pressure level when compared to concrete, so forgoing detergent increases the time it takes to spot clean stains and debris once you finish with the pressure washer. Brick is especially porous, so the less water you use on it, the better.

Yes, it is important to wash your deck before painting to ensure the paint applies well and adheres properly. While you don't have to use a pressure washer, it is one of the most efficient cleaning methods. Pressure washing can quickly remove dirt, wood fibers, and flaked paint, getting deeper into the wood than manual scrubbing. You can also clean the deck with a stiff broom and a cleaning solution. Regardless of the method, a clean surface is essential for good paint adhesion. Make sure the deck is completely dry before applying any paint.

Yes, pressure washers can remove rust stains from concrete. However, when coupled with an acid treatment, they can be even more effective. Just be sure to use a minimum of a 15-degree nozzle to prevent damage to the surface, and users must also be careful not to get in the way of the pressure washer’s jet as they can cut through skin and cause injury.