Top-rated well and pump technicians.

Get matched with top well and pump technicians in La Junta, NM

Enter your zip and get matched with up to 5 pros

Need a pro for your well and pump service project in La Junta, NM?

Select your specific project to find the pro for you.

Find Well and pump technicians in La Junta

Avatar for Art's Plumbing and Heating, Santa Fe, NM
Art's Plumbing and Heating, Santa Fe, NM
4.0(
4
)

Serving La Junta, NM and surrounding areas

In business since 2000

Free estimates

Emergency services offered

Hello, and welcome to Art's Plumbing and Heating & Cooling! We are a family-owned and operated air conditioning, furnace, plumbing and drain repair and installation company, and I would love for our team to have the opportunity to serve you! We take pride in offering the best customer service, the most technically trained service professionals and the friendliest team. EMERGENCY SERVICE AVAILABLE..

Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+12

Recommended by100%of homeowners
Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,688
)

Serving La Junta, NM and surrounding areas

In business since 1971

Credit card accepted

"Well, the first time the replacement was ordered it was the wrong one, which of course, delayed the installation a week. When it was finally installed I had to pay an additional $850 for code upgrades. This I was not informed of by Home Shield. Then we noticed that there was water on the garage floor and found that the pipe coming in from the wall was leaking at the wall so had to call the plumbing company back out to fix it. They first tried to say it was not their fault but since there wasn't a leak before they installed they did fix it. I have used Home Shield a few times before and never had a problem. Some of the companies they use are not the best so you have to research them before you commit. I have found HS service to be good if you do your homework. At the end of the day I was without hot water for almost 3 weeks but it was do to the plumbing company they sent out."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Wells and Pumps questions, answered by experts

How do you set your well’s pressure tank? All you need to do is first drain the tank of water and find the pressure switch. Remove the switch cover and adjust the switch with a wrench—clockwise to increase water pressure, and counter-clockwise to reduce it. Each complete turn of the nut on the switch should equal 2.5 psi. Once this is done, replace the switch cover. All that’s left is to adjust the pressure of the tank itself using an air compressor and a tire gauge to support the new setting.

For the most part, choosing between 30/50 psi and 40/60 psi is based on your water-pressure preference. However, it can also depend a little bit on your house—if you have older plumbing, a lower water pressure can be easier on the pipes (and a bit more gentle on your well pump). 

The lower 30/50 pressure is usually enough for a single-story home, but you may want 40/60 if you have multiple stories, as the extra pressure helps water flow smoothly up to the second floor.

Common problems include low water pressure, no water, and strange noises. Regular maintenance prevents many issues.

The cost to fix low water pressure heavily depends on the cause of the problem. In some cases, all you need to do is open a valve, which won't cost you anything. However, plumbing repairs cost an average of $325, so if you have a broken pipe or other plumbing problems, you might pay something close to that figure, or more, depending on the issue.

Consider replacement if the pump is over 10 years old or has recurring, costly issues.

The La Junta, NM homeowners’ guide to well and pump services

From average costs to expert advice, get all the answers you need to get your job done.