Top-rated well and pump technicians.

Get matched with top well and pump technicians in Hernandez, NM

Enter your zip and get matched with up to 5 pros

Need a pro for your well and pump service project in Hernandez, NM?

Select your specific project to find the pro for you.

Find Well and pump technicians in Hernandez

Avatar for Art's Plumbing and Heating, Santa Fe, NM
Art's Plumbing and Heating, Santa Fe, NM
4.0(
4
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Hernandez, NM and surrounding areas

In business since 2000

Free estimates

Emergency services offered

Hello, and welcome to Art's Plumbing and Heating & Cooling! We are a family-owned and operated air conditioning, furnace, plumbing and drain repair and installation company, and I would love for our team to have the opportunity to serve you! We take pride in offering the best customer service, the most technically trained service professionals and the friendliest team. EMERGENCY SERVICE AVAILABLE..

Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+12

Recommended by100%of homeowners
Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,688
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Hernandez, NM and surrounding areas

In business since 1971

Credit card accepted

"Well, the first time the replacement was ordered it was the wrong one, which of course, delayed the installation a week. When it was finally installed I had to pay an additional $850 for code upgrades. This I was not informed of by Home Shield. Then we noticed that there was water on the garage floor and found that the pipe coming in from the wall was leaking at the wall so had to call the plumbing company back out to fix it. They first tried to say it was not their fault but since there wasn't a leak before they installed they did fix it. I have used Home Shield a few times before and never had a problem. Some of the companies they use are not the best so you have to research them before you commit. I have found HS service to be good if you do your homework. At the end of the day I was without hot water for almost 3 weeks but it was do to the plumbing company they sent out."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Wells and Pumps questions, answered by experts

Most well pump pressure switches have a factory setting of 30 to 50 PSI. There’s some flexibility with this if you’d like a lower or higher water pressure, but remember that it should sit 2 to 3 PSI above your well tank’s general pressure setting.

The inside of your pressure switch cover will usually indicate minimum and maximum settings—going below and above the numbers might damage your well pump.

DIY is not recommended due to safety and technical requirements. Hire professionals for accurate diagnosis and repair.

Every 1-2 years to ensure optimal performance and prolong lifespan.

Excessive pressure (above 80 psi) puts too much stress on plumbing pipes, joints, and fixtures. This can lead to leaks and burst pipes. Plus, it shortens the lifespan of appliances, can waste water, and can raise your utility bills. High water pressure might feel like a gift, but it’s actually a silent threat to plumbing.

Normally, when your well pump turns on or off, you’ll hear a small click. This isn’t anything to worry about, but it can be a problem if it’s clicking continuously. This can indicate that the well pump is short cycling—the pump continuously turns on and off.

This can wear out the motor and provide uneven water flow. If this happens, you may need to get it looked at by a well pump professional to see if you need to repair the switch or pump.

The Hernandez, NM homeowners’ guide to well and pump services

From average costs to expert advice, get all the answers you need to get your job done.