Get matched with top floor polishers in Guadalupita, NM

Dust mops are the best option for tackling dirt and dust on marble floors. Vacuums aren’t a good idea as the brushes and beater rolls can scratch and damage your marble floors. If you must use a vacuum, make sure your vacuum has a setting for hard floors, and take care not to apply too much pressure when rolling the vacuum across your marble floor.

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.

Using too much soap or floor cleaner can leave your laminate floors looking dirty or cloudy after mopping. Only use a teaspoon of soap or cleaning solution in a gallon of water. Additionally, always be sure to sweep or vacuum laminate floors before mopping to ensure you pick up dried grit, hair, and dust that can be harder to catch with a wet mop.

Professionals use various tools and cleaning solutions based on the type of floor they’re cleaning. They often use industrial steam cleaners to pull debris out of the carpet. For localized stains, they may use a commercial cleaner or a mixture of water, vinegar, and dish soap. For tile, they’ll typically use dish soap and hot water, plus a mixture of baking soda and hot water for the grout. For cleaning wood floors, they might use a low-heat steamer, a mop with an oil wood floor cleaner, or a mixture of hot water, vinegar, and lemon juice.