Get matched with top door repair pros in Dixon, NM

"Bob Reule and his staff worked with me throughout the entire process, While I knew that the house needed new stucco and the color needed updating I was not certain of much else.  Bob and Jay, one of his staff, were extremely helpful and patient in helping me with color choices for the stucco and the trim.  As so often happens with older homes, as they progressed with the prep work, it became apparent that some other things also needed attention.  I ended up replacing three exterior doors in the back of the house prior to the re-stuccoing. As a result, the Reule staff had to coordinate their work with additional workmen. It required adjustments in scheduling, but they were very cooperative in doing so. Reule did the re-framing and installation of a new side side door in the garage, replacing an old weathered door.
A large bush had caused a great deal of damage to a yard wall. This caused misalignment of the side-gate and made securing of the gate difficult. Once the bush was removed, the men repaired the side wall and realigned the gate. The yard walls, bordering the front yard, were waist high and stucco. Due to time and weathering the stucco was in need of some cosmetic work.  Minor repairs were done, the stucco was patched and color match the house.
A stucco half wall, serving as a base for a long flower box, extended from a structural pillar near the front door along the entryway walk.  It had severe water damage and "imploded" down into the base. It was decided to remove that structure up to the pillar.
The structural pillar was just a few feet from the front door and had an open level portion under the eve.  Pigeons had begun to roost there and were making a mess.  After discussing the problem with the workmen, it was decided to extend the stucco up an additional few inches and eliminating the perching area. Problem solved (so far!).
The paint mixture designed to match the stucco color, turned out to not be an exact match for the garage doors and the trim around them.  It took a few attempts, but Jay kept working with it and was able to come up with a paint "recipe" that matched the stucco.
Jay and the workmen were always on time, did what they said that they would do (sometimes more) when they said they would do it, stayed on schedule, were courteous, easy to work with and very helpful. Bob stopped by intermittently to see how things were going, and was kept updated through Jay, as well. 
While this ended up as a much bigger undertaking than I had initially anticipated, everything that was done was long overdue and with an eye on resale one day. Everyone I dealt with at Ruele Sun Corp was incredibly helpful. Bob and Jay were a terrific help throughout the process.I love how my house now  looks and would readily recommend Ruele Sun Corp for re-stuccoing.

"

"Hello, My name is Phil Carr-Jones, I am reviewing my experience of working with and building my own kitchen, using cabinets and doors from Arkansas Wood Door. While I am an Episcopal Priest, it turns out I get to do a lot of things they don't teach you in seminary. Over the years, I have had to get fairly skilled in all the trades, including, no surprise, carpentry. But I am by no means an expert. For instance, I employed a retired carpenter to help out with the crown molding and other trim. Apart from that though, this is all my and my wife's work. So let me state up front, Arkansas Wood Doors is the go to place for the DIY’er who is thinking of remodeling their own kitchen. Here's why: I searched the web for months, literally doing comparisons and research on flat pack rta cabinets. I went to the big box store for a design and pricing in their three lines of cabinets, and I went in for a consult with a small custom shop in my area. Here's what I found. 99 outof 100 rta cabinet companies have their product made in china which means the standards for formaldehyde are going to be as fishy as they smell, plus you can only get cabinets in fixed sizes so if you looking to eeck out every last inch of space you're going to lose a lot and you'll be using a lot of filler strips wasting what could have been useful storage. If you want to go custom, then you only have less than a handful of online options, companies that will make to order in any dimension. For instance, I only wanted an 8 inches deep spice cabinet to allow for greater working room over the counter. My wife and I are pretty serious about cooking from pastries to mains and sides. We want a very serious kitchen. Plus, I'll tall so I needed the room. In any case, if you want something custom your choices online are limited. The big box stores don't really do custom and are just as limited in their options as are the online rta places. Most online rtas offer far cheaply made boxes with construction methods less sturdy. I have found that if I buy cheap, I shouldnt expect my kitchen to hold up past a few years. The finish will fade. The drawers will warp. The joints will open up. The big box stores basically offer the same thing, too. When I go to a big box store to buy something, I do it knowing I probably willl get a year out of it, whether that’s a lawn chair of a power tool. I mean when was the last time you regretting spending too much money on a better grade of power tool? So if you want quality, a better and safer grade building material and much wider choices in sizing then your basically down to three or four options. I went with Arkansas Wood Door and am completely pleased and impressed by the experience. Now I could have spent twice what I did and gone to a small custom shop and gotten the same thing, but I am in to saving money and frankly I enjoy the challenge. AWD worked with me directly. Working up the order and getting the plan for each box just right. If you have never designed and built a kitchen before, there are plenty of tips and guidance on the web and I recommend you heartily research all of the aspects and complications involved. I hit a couple of unexpected bumps. But more about that below. So do your research. For instance you can save a lot of money by building the plinths yourself and only order squared off boxes without the toe kick. By making the platform on which you place the lower cabinets first, you can get that plumb and level, so throwing up the boxes is a breeze. And again, the cabinets are also less expense, a complete all around win. AWD uses an easy system for matching up box parts so assembly was easy. No special tools required. Given the many parts and I used a mix of frameless and face framed cabinets, there was a moment or two when in amongst all the materials I got nervous about having everything I needed, but low and behold, all was right there in the end. I also recommend the concept from French cooking "mis en place" that is have all your ingredients in place and all your tools where you need them before starting out. Also, it was a lot easier to work with my wife than doing it alone, but I did a few by myself and so if that is your only option than you should have no problem. I've assembled a lot of cheaper Swedish flat packed furniture in my day, and the quality and sturdiness of AWD leaves no doubt about how long these will last. Just rock solid. Great thing about AWD is the cost to quality ratio. Cant beat it. Which also means if you make a mistake the replacement is so reasonable it becomes not big deal. I mis-measured one box and so I needed to order the right size. Worked out fine, but that was because AWD had an incredibly fast turn around. The other few reliable companies are several weeks to months. And these other places are crazy expensive. And in truth, the other companies are a complete rip off on trim and accessories. AWD pricing was so amenable that my mistakes cost me so little in comparison with what I was saving. So there's a built in confidence for the first timer. Also AWD made one mistake on the placement of a hinge in two doors. They immediately and without question remade them and sent them out in under ten days. You just can't get that service anywhere in the custom cabinet world. It was so affordable I upgraded on one side to black walnut. Trying doing that at the other quality shops. The quality of the roll out drawers and top drawer boxes is superb and the hinges and under-mount sliders are top grade excellent. The hardware was the easiest part frankly. Their system, for lining up the hardware is just so easy. Drill driver is all you need as the placement is already leveled for you. SO: high end quality custom built cabinets, superior custom support, fastest turnaround in the marketplace, most affordable pricing out there, excellent hardware, and oh yeah, I almost forget, color choices. They offer complete line of lacquer - just pick a SW color and they'll match it. SO completely and truly custom for a fraction of cost without sacrificing any quality. The Rev. Philip Carr-Jones"

"Bill did an excellent job of filling, sanding, and painting the columns, vigas, and latillas. For the wood under the portal where we wanted to maintain stain, he did a beautiful job of matching the wood and making the filled areas look natural. He also painted our ductwork and other metal components to color match the stucco, repairing the stucco in a few places along the way. Bill is extremely reliable, meticulous in his cleanup, and fairly priced. Our next door neighbors saw Bill's work and hired him for their project."

"Mariano Aragon did a fantastic job of repairing some seriously damaged areas in my kitchen and guest bathroom. After the plumbing repairs were complete both rooms were a disaster area. Mariano came to the rescue, rebuilt all the structural damage and did beautuful refinishing of the plaster and and a masterful job of marrying the new tiles he replaced with the existing tiles that weren’t damaged. I am more than happy with the final results! Mariano was cheerful, thoughtful and completely reliable through out the days of his restoration project for me. I highly recommend him for his excellent, inventive and superior work!"

"He was very nice to talk with and repaired our washing machine. He even helped sweep the water out."

Custom Paining, Drywall Repairs, Baseboard, Flooring, Trim Work, Stucco Patches, Garbage Disposals, ect.

"The project involved building two walls, adding a door, building a closet, matching texture and painting. I got three bids on the project. PT'S bid was about half the price of the other two contractors. I was a little skeptical but selected PT and I am very happy that I did. PT completed the project in only four days. One contractor told me it would take two weeks. I was also extremely happy with the quality of workmanship and materials. Both were top notch. I was also impressed with the punctuality and courtesy of the workers. I always felt comfortable having them in my house. Overall I am very happy with PT'S work and would recommend them for other remodeling projects, particularly for anyone on a tight budget as I was."

Been in business since 1990. No project too big or too small. Customer satisfaction is our motto, financing is available. Senior discount for Angies list customers.

Our mission at Hampton Enterprise LLC is to provide clients with superior customer service, quality work and speedy service in all aspects of their home improvement needs. Licensed, insured and trusted since 1989; come discover the Hampton difference today!\n\nWe specialize in the installation and repair of Windows, Doors, Flooring, Sinks, Bathtubs, Showers, Sprinkler Systems and much more. We also offer Interior and Exterior Home Painting, Custom Welding Fabrication and Carpentry.Localy in your area just call and i will call back with a local number thank you . from James Hampton\n\nAL.Dothan 334-648-3817,\nAL Birmingham 334-648-3817,\nAL Huntsville 334-648-3817,\nAL Mobile 334-648-3817,\nAL Tuscaloosa 334-648-3817,\nAL Montgomery 334-578-4761,\nAR Little Rock 334-648-3817,\nAZ Phoenix 334-648-3817,\nCA LosAngeles/Sacramento 334-648-3817,\nCO Denver/Colorado Springs 334-648-3817,\nCT Hartford 334-648-3817,\nDE Dover 334-648-3817,\nFL Tallahassee 334-648-3817,\nFL Cape Canaveral/ Cocoa 334-648-3817,\nFL. Destin 334-648-3817,\nFL Gainsville 334-648-3817\nFl Jacksonville 334-648-3817,\nFL Orlando 334-648-3817,\nFL Panama City 334-648-3817,\nFL Tampa 334-648-3817,\nFL Miami 334-648-3817,\nGA Atlanta 334-648-3817,\nGA Albany 334-648-3817,\nGA Augusta 334-648-3817,\nGA Columbus 334-648-3817,\nGA Macon 334-648-3817,\nGA Valdosta 334-648-3817,\nIA Des Moines 334-648-3817,\nID Boise 334-648-3817,\nIL Chicago/Springfield 334-648-3817,\nIN Indianapolis 334-648-3817,\nKS Levenworth/Topeka 334-648-3817,\nKY Frankfort 334-648-3817,\nLA New orleans/Baton Rouge 334-648-3817,\nMA Boston 334-648-3817,\nMD Annapolis 334-648-3817,\nME Augusta 334-648-3817,\nMI Detroit/Lansing 334-648-3817,\nMN Saint Paul 334-648-3817,\nMO kansas City/Jefferson City 334-648-3817,\nMS Jackson 334-648-3817,\nMS Biloxi 334-648-3817,\nMS Gulf Port 334-648-3817,\nMT helena 334-648-3817,\nNC Raleigh 334-648-3817,\nND Bismark 334-648-3817,\nNE Lincoln 334-648-3817, \nNJ Trenton 334-648-3817,\nNM Santa Fe 334-648-3817,\nNV Carson City 334-648-3817,\nNV Las Vegas 334-648-3817\nNY Albany 334-648-3817,\nOH Columbus 334-648-3817,\nOK Oklahoma Ciy 334-648-3817,\nOR Salem 334-648-3817,\nPA harrisburg 334-648-3817,\nRI Providence 334-648-3817,\nSC Columbia 334-648-3817,\nSD Pierre 334-648-3817,\nTN nashville 334-648-3817,\nTX Austin 334-648-3817,\nUT Salt Lake City 334-648-3817,\nVA Richmond 334-648-3817,\nVT montpelier 334-648-3817,\nWI Madison 334-648-3817,\nWV Charleston 334-648-3817,\nWY Cheyenne 334-648-3817

"Exceptionally well. I had a home where I was representing the seller and we needed a few items fixed prior to bringing it to market. Juan did an amazing job, the seller was very happy and we sold the home for 10k above what it was listed at. HIGHLY recommend and would use again. Juan also helped to clear junk and clean a home last week so that we could close promptly and the new buyers were ecstatic!"