Get matched with top arborists in Carlsbad, NM

It could be anywhere from weeks to years for a dead tree to fall. A dead tree falls based on its weight, how it leans, the state of its roots, the state of decay, and what local windstorms are like, among other factors. Since it’s hard to predict the fall’s timing, it’s important to cut down a dead tree quickly and avoid any unpleasant surprises.

The best way is to start controlling tree height long before it grows too large, via careful pruning through the years. But that’s not always possible. If a tree has become too high or too large, use selective pruning to remove the most troublesome branches, one by one, without topping the tree. Gently shaping a tree like this can, over time, correct problems. You can also find growth inhibitors to spray on a tree to stop it from growing too rapidly, but use these sparingly if at all.

After a big storm, you may not be sure if a tree was struck or not. Look for the telltale long scars, like strips or gouges in the bark of the tree, running in sometimes jagged lines down the length of the trunk. These scars will often show vulnerable living wood inside the tree. It’s also common to see scorched or wilted leaves on the side or top of the tree where lightning struck.

We don’t recommend DIY tree trimming for a few different reasons. First, the tools required to trim a tree can be costly, up to $1,100 or more, for the ladders and specialized saws needed. 

Safety is another concern, especially when working with more mature trees. As a guideline, you should only DIY tree trimming when branches are less than two inches in diameter. Any more, and the safety risk becomes too high, which could lead to catastrophe. For this job, it’s safest to let a tree-trimming professional assess the work needed.