Top-rated pressure washers.

Get matched with top pressure washers in Bloomfield, NM

Enter your zip and get matched with up to 5 pros

Need a pro for your pressure washing project in Bloomfield, NM?

Select your specific project to find the pro for you.

Find Pressure washers in Bloomfield

D & R Services
4.6(
47
)
Exterior Surfaces - PowerwashingExterior Surfaces - Powerwashing - For Business

Serving Bloomfield, NM and surrounding areas

In business since 2010

Free estimates

Emergency services offered

"People have actually asked me where I got the slate!  Both the driveway and the backyard look brilliant.  They showed up when they said they would, did the job in a timely manner and were incredibly professional.  From now on whenever I have any jobs in my house that need concrete I will not hesitate to contact them.
"
Additional Photos
stamped concrete and curb
stamped concrete and curb
stamped concrete and curb
tile

+107

Recommended by82%of homeowners
Avatar for Anasazi Home Services
Anasazi Home Services
5.0(
3
)
Exterior Surfaces - Powerwashing

Serving Bloomfield, NM and surrounding areas

In business since 2023

Free estimates

Emergency services offered

"Arickis has done many home repair and small building projects for me. He does a meticulous work with care for details. I appreciate his professionalism as well as his cheerful, friendly attitude. I have been more than satisfied with the jobs he has done for me and would highly recommend him!"
Subfloor restoration
Shed renovation w/ new roof
Flooring renovation w/ transitions (Laminated)
Ground leveling
Entire house flooring installation (Laminated)

+5

Response time2 days
Response rate100%
Showing 1-10 of 44
Pressure Washing questions, answered by experts

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.

If you’ve looked at power washing before and after photos, you might be wondering if this option isn’t the better cleaning solution for a wood fence. In fact, it just might be, especially if you’re struggling with issues like mold or embedded dirt. Keep in mind that the only difference between these two methods is that power washing uses hot water and pressure washing doesn’t, but sometimes such a small distinction can have a huge impact.

It generally takes 60 minutes to pressure wash a 19-foot by 19-foot deck. If you are using a pressure washer for the first time, be sure to take extra time to read all directions, select the right nozzles, and test a small portion of your deck before diving into the task.

You can use a pressure washer to clean a whole host of surfaces. The exterior siding of your house is one of the most popular spots, as well as your driveway, garage floor, patio or deck, and even your outdoor furniture. Just be mindful about the amount of pressure you apply to different materials—concrete can handle a lot more than wood, for example.

Even at the lowest setting, there’s always a risk that pressure washing might damage your shower or tub. Never use this technique if there’s pre-existing damage in your shower or tub, like peeling caulk, sealant, or cracked tiles. And skip this method entirely if there are any wood features present.

The Bloomfield, NM homeowners’ guide to pressure washing services

From average costs to expert advice, get all the answers you need to get your job done.