Best deck staining pros near Westville, NJ

Yes, it is generally a very good idea to seal your deck after pressure washing. Power washing removes not only dirt and debris but also a thin layer of wood, leaving the surface exposed and more susceptible to weathering. Sealing is almost always needed after this process. After a general cleaning, sealing isn't automatically necessary if the existing sealant is still intact. You can test the surface by placing a few drops of water on it. If the water beads up, the sealant is working. If it soaks into the wood, it's time to apply a new sealant. If it has been a few years, it's wise to remove the old sealant, wash the deck, and reseal for maximum protection.

Yes, staining or sealing a cedar deck or fence is highly recommended to extend its lifespan, typically by five to 10 years. While cedar is naturally resistant to mold and mildew, it can still fall victim to moisture, sun exposure, and rot over time. Applying a treatment creates a protective shield that helps prevent splintering, fading, and decay, preserving the wood's strength and appearance. A combination stain and sealer often provides the best protection, as it soaks into the wood grain rather than just sitting on top. This offers superior defense against UV damage and rot and lasts longer than a sealer alone. To maintain the wood's natural look, consider using a near-translucent stain. You should plan to reapply the stain or sealer every two to three years.

It is not always necessary to remove old stain before restaining a deck. If the previous stain is in good condition and is compatible with the new stain, you may be able to apply a new coat after thorough cleaning. However, if the old stain is in bad condition, flaking, or peeling, it is best to remove it completely to ensure an even surface and proper adhesion for the new coat. Staining over a damaged layer can lead to an uneven finish and poor penetration. For best results, test a small area first and consult the stain manufacturer's guidelines.

The number of coats you need to apply when whitewashing a surface depends on how opaque you want the final product to be. If you're going for a transparent, barely there look, a single coat or two may suffice. For fuller coverage, you'll want to use multiple coats. Another option is to use a less diluted paint to get a thicker coverage.