Get matched with top sonic cleaning pros in Wilton, NH

Roof raking helps clear snowfall from your roof and, in turn, you hope that this prevents ice dams. But can roof raking actually cause them? Generally, no, it cannot. But you should note that while, in some cases, you might successfully prevent ice dams from forming near the edge of your roof by keeping it cleared with a roof rake, they could still form higher up on the roof, where you are unable to reach. This may leave you wondering: Does roof raking prevent ice dams? While it is not a 100% guaranteed way to prevent them, it does help.

In most cases, it is best to leave icicles on your roof and allow them to melt naturally. You should only consider removing them if they are heavy enough to cause damage to your home or pose a risk to people below. Since removing icicles can be dangerous, it is recommended to hire a professional for the job if you have immediate concerns. To prevent the issue from recurring, you should address the underlying cause, such as improving your home's insulation or installing roof heating coils.

It’s possible that installing solar panels can lead to mold on the roof. The panels themselves are not the issue. Problems caused by improper installation—such as roof leaks and mounts that aren’t sealed properly—can cause mold. Another potential cause of mold is debris accumulation under panels, which can trap moisture. If you live somewhere with extreme snow, rain, or hail, your home could be more prone to mold.

Moss grows in dark areas of roofs, including in corners and gutters. If left alone, it can grow under roofing and cause permanent damage. Here’s how to remove moss from metal roofs: 

• Soak the moss to soften it

• Scrub it away with a soft-bristled brush, or pick it off with your hands (be sure to wear gloves)

• Use a moss remover that’s compatible with metal roofing, following the manufacturer’s directions

• Remove dead moss and rinse the roof thoroughly

• Prevent future moss growth by trimming branches, cleaning gutters, and attaching zinc strips to moss-prone areas