Best septic tank pros near Wisner, NE

A septic tank riser features a base ring that you need to install flush to the opening of the septic tank. After thoroughly cleaning the opening of the tank, fit the base ring over the opening and use a butyl sealant rope to create an airtight seal with the tank’s rim. Cut the riser rings to the appropriate height and stack them on the base ring. Then, install the riser lid. This task might be taken on by an experienced DIYer, but you should always call a septic tank professional if you are unsure of your skills.

Most well pump pressure switches have a factory setting of 30 to 50 PSI. There’s some flexibility with this if you’d like a lower or higher water pressure, but remember that it should sit 2 to 3 PSI above your well tank’s general pressure setting.

The inside of your pressure switch cover will usually indicate minimum and maximum settings—going below and above the numbers might damage your well pump.

Frozen well pipes make themselves known quickly, as your faucets slow down to a trickle or shut down completely. If you notice a serious reduction in flow in the winter from toilets, showers, kitchen faucets, and other plumbing fixtures, a frozen pipe or two is to blame. Another tell-tale sign is frost or ice on exposed pipes outside. 

Good news: You’ll naturally increase the bacteria in your septic tank simply by using it. If you want to encourage more good bacteria growth, stop using products and household cleaners that kill bacteria, such as bleach and harsh chemicals. Never flush antibiotics, and make sure only water and waste go down the tube—not paper products, feminine hygiene products, or diapers.