Get matched with top drain pipe installers in Sargent, NE

If you don’t want to remove the sink stopper, pour ½ cup of baking soda and 2 cups of boiling water down the drain. Start by pouring 1 cup of boiling water, then the baking soda, followed by the remaining cup of boiling water. Use caution as boiling water can damage PVC or other plastic piping. Using a scrub brush or slightly abrasive sponge, clean the top of the stopper, and run the faucet to ensure the drain is clear and the stopper is clean. 

Sealant doesn’t need to be applied to the bolts, but it can be a good way to stop an active leak in the moment. However, don’t rely on it as a cure-all; instead, make sure to fix the problem at the source by changing or tightening the bolts. 

If you do use sealant, make sure to spread it thickly and evenly across the bolts and the tank's porcelain.

To clean gunk out of a sink drain, pour in a half cup of baking soda, then 1 cup of white vinegar. The two will react chemically; let them fizz for 15 minutes, then rinse with boiling water. Repeat these steps if necessary for particularly dirty sink drains, and consider a drain snake if there are clogs.

Yes, drain stoppers do come out. In some cases, you can twist them counterclockwise to remove them. You can lift some drain stoppers halfway to the raised position and unscrew them. For others, you will need to lift the drain stopper to the raised position and unscrew the stopper from the stem underneath the top of the stopper.