Best floor polishers near Neligh, NE

Wood floors should be polished every two to four months to maintain a shine and to keep them protected from daily wear and tear. More frequent maintenance includes dry mopping the floors daily and cleaning spills immediately, using a spray mop and cleaner weekly to remove any built up dirt or grime, and sanding and refinishing the floors every three to five years.

Yes, but with caution. A floor grinder is intended to level and polish concrete, so it is a very powerful tool. To remove paint, the floor grinder should be set to 35 square feet per minute or less to minimize the pressure without the use of pocket weights. You might need to go over the surface two times to get any paint that has sunk into the concrete’s pores.

Yes, a magic eraser can remove candle wax. You can use it to remove all the candle wax from start to finish. Another option is to remove all large clumps with a dull knife and then pull out your magic eraser to finish the job. However, while the results can be impressive, a magic eraser shouldn’t be used on all surfaces since it can potentially damage them. If you try this method, test a small, hidden spot first and proceed cautiously.

Before installing shoe molding, evaluate redoing or refinishing any floors and painting your walls or baseboard before putting on your shoe molding. If you don’t already have baseboard trim, you should install that before adding shoe molding. Shoe molding is the final touch. Additionally, a carpenter or other professional that’s installing shoe molding might also give you a deal on installing crown molding and replacing other trim if you get them done at the same time.