Get matched with top floor polishers in Madison, NE

Before starting on a full refinishing project, determine if your floors need to be completely sanded down to the bare wood or if the damage is shallow and mostly cosmetic. Deep scratches and gouges will require you to rough sand using a drum sander or belt sander, but small surface scratches or floors that have only lost their luster don’t need a complete overhaul. Instead, you can skip the rough sanding step and sand-screen the old finish with a buffer, removing only the top layer of polyurethane.

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.

If you have waxed floors or floors with a penetrating stain or oil, you can shine them up with some more wax and a cloth or floor buffer. After cleaning the floor thoroughly, apply wax to the floor in small sections and use a clean, dry cloth or towel to buff it until it shines. You can also use an electric polisher, which is especially handy for large floors.

Most experts agree that the best thing with which to clean epoxy floors is a diluted mixture of ammonia and warm water. You can also use mild dish soap diluted with warm water or a degreaser (such as Simple Green or Goof Off) diluted with warm water. Some soap-based cleaners can leave a haze. If you notice this, further dilute the mixture with water or use a different detergent that does not leave a film. You should never use harsh cleaning chemicals, any type of acidic compound (such as vinegar or citrus-based cleansers), or harsh scrubbers like steel wool or hard bristle brushes.