Best toilet pros near Minden, NE

Brown stains in your toilet bowl are most likely limescale. Limescale happens from lime being left behind from hard water evaporating. Once dried out, the minerals also catch dirt and bacteria which eventually accumulate into the brown or blackish stain you see in your toilet. To remove thick and hard limescale from your toilet, use a mixture of vinegar, lemon juice, and baking soda, and scrub with a metal scrubbing brush.

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

Plumbing installation costs in renovations typically range from $300 to $1,500 or more, depending on the complexity and specifics of the project.

The cost to install a new toilet typically runs from $225 to $530. This doesn’t include the price of the toilet itself, which can cost $90 to $1,500 depending on the model and features you choose. You can save money if you choose to install a toilet yourself. However, you might want to hire a pro for this project.

"Due to the many complexities of replacing a toilet flange, it is typically a job best left to the pros," says Jeff Botelho, Angi Expert Review Board member and plumber. "Many times it isn't as simple and straightforward as 'pop off the old one and pop on a new one' because the flange is either glued on (PVC/ABS), soldered on (brass/copper), or caulked in place with a lead & oakum joint (cast iron) and none of these things can be easily reversed without years of training and repetitive practice."