Best toilet pros near Franklin, NE

Many parts of your plumbing system can fail, but clogged drains are one of the biggest plumbing problems you’ll likely encounter. From your kitchen sink, bathroom sink, or bathtub, there are plenty of opportunities for gunk, hair, food scraps, and more to get stuck in drains. When this happens, water will slowly drain, leading to standing water, bad odors, drain flies, and other issues.

Many homeowners can handle a minor clog themselves, but if you have a clog in your main line, you’re best off hiring a local plumber to get the drain back to its normal flow rate.

The normal water level in a toilet bowl is about halfway full. The water should sit above the P trap drain because this creates a seal and suction. When you flush the toilet, the suction keeps sewer gases from entering your house through your toilet. Anytime the water level is higher or lower than half full, you need to make adjustments or replace broken parts.

There are a few reasons why this could be the case. More than likely, your flapper is worn out and needs to be replaced. When it’s worn out, it lowers the water pressure during each flush leading to inefficient flushing. Luckily, replacing a toilet flapper is a simple repair that should only take about 30 minutes.

Silicone-based caulk is known for its waterproofing qualities, so it’s the best option for any bathroom area. While it’s often more expensive, it will provide a better, longer-lasting seal than acrylic or latex caulk. Use it along the base of the toilet to prevent leaks and keep the area clean and protected.