Get matched with top drywall pros in Laurel, NE

The easiest way to cut holes in drywall for electrical boxes is to use a spiral saw with a drywall router bit. Hang the drywall without cutting out a hole for the box, but make sure you measure and mark where the box is located on the wall. Once you screw in the drywall sheet, drill a small hole into the box void, insert the spiral saw bit, and move it around the edge of the box using the inside wall as a guide. You can also use an oscillating multi-tool with an electrical box cutout for fast, professional results.

Level 4 is the most commonly used drywall finish for visible interior walls. Finishing the drywall to Level 4 rovides a smooth surface ready to be painted with flat paint. 

Level 2 and 3 finishing are also common, particularly on walls that will get covered.

You should start looking for a drywall installer by choosing a local company with positive online reviews and ratings with the Better Business Bureau (BBB). Next, confirm that the professional is properly licensed using Angi’s contractor licensing tool, and ask the installer if they are fully insured. It’s a good idea to ask for recent customer references and call them to get their honest opinion about the contractor and their work. You can also ask the installer if they guarantee their work or provide a workmanship warranty.

The best way to make long, straight cuts is to use a utility knife and a T-square to score the sheet, snap along the score, and then finish the cut by cutting through the paper on the opposite side with the utility knife. If you’re making small cuts, curved cuts, or cutouts for electrical boxes or light fixtures, you can use a manual jab saw to keep costs down, but an electric spiral saw or oscillating multi-tool will get the cleanest, fastest cuts possible.