Get matched with top drain pipe installers in Laurel, NE

Flex is necessary for soldering copper pipe. This acidic paste attracts the solder, pulling it deeper into the joint so the solder fills all the gaps between the two metal fittings. While many solder products contain small amounts of flux, you need to apply the additional flux paste to ensure you achieve a water-tight fit between the two copper pipes.

Ensuring your toilet will fit starts with measuring the rough-in, but there are a few other factors to consider. The toilet tank's height and the toilet's depth should fit comfortably within the bathroom’s current setup. When considering depth, look at the walking space around the toilet to ensure it fits in the bathroom.

Try to tighten the clevis crew and adjust the lift rod if your sink stopper won’t stay up. Sometimes your screws became too loose over time, and as a result, there wasn’t enough resistance to keep the sink stopper up. If a damaged lift rod is the cause of the problem, you will need to replace it with a new rod.

In general, PVC (polyvinyl chloride), PEX (polyethylene), and copper are the three piping materials used in new constructions when adding water supply lines. There are some caveats. PEX and copper are considered ideal when running lines that will handle hot water because they are not at risk for melting and warping the way that PVC piping can. At $0.40 to $4 per linear foot, PEX is considered more affordable than copper pipes, which cost $2 to $12 per linear foot. PVC is considered appropriate in water lines for cold taps only.