Get matched with top pressure washers in Hemingford, NE

The Centers for Disease Control and Prevention (CDC) recommends using an EPA-registered disinfectant product to disinfect a house properly. If such a product isn't handy, a strong bleach solution can disinfect high-touch surfaces. Before hiring a professional, be sure to discuss the type of chemicals and disinfectants they plan to use to ensure they’re safe for household use.

It takes about 15 minutes per each side of an exterior house to apply detergent and 15 minutes to remove it, so you’ll need roughly two hours for the whole job. However, that length of time may decrease or increase depending on the size of your home, so always budget a little more than expected to ensure you don’t end up rushing to get it done.

While power washing isn't a requirement before you stain a fence, it can make the job much easier and faster while reducing manual labor requirements. The stain will not work if the wood is full of dirt and dust, so power washing, sometimes called pressure washing, is a fast and effective way to prepare the wood for staining. Remember that you need to stain or repaint relatively soon after the wood has dried so that there isn’t time for dust and dirt to build up again. 

The amount of pressure, measured in psi, that you should use depends on what you’re washing. Very tough materials like concrete, stone, and masonry can handle a high psi of 2,500 to 3,000, but materials like wood require a bit of a lighter touch. To clean your wooden deck, you’ll want to use your pressure washer on the lowest setting, around 600 psi, especially if it’s made of soft wood like pine or cedar.