Q: How do you get rid of heavy hard water deposits?

• <div><p>It depends on the type of surface. For instance, if you&rsquo;re trying to <a href="https://www.angi.com/articles/how-to-remove-hard-water-stains.htm">get rid of hard water deposits</a> on glass, you can spray vinegar onto the surface and wipe it off with a soft cloth or non-abrasive sponge. However, if the deposits are on granite or natural stone, it&rsquo;s better to use baking soda and water rather than vinegar or other acidic cleaners.</p></div>

Q: Is it OK to oversize a water softener?

• <div><p>It&rsquo;s not a good idea to <a href="https://www.angi.com/articles/what-size-water-softener-do-i-need.htm">oversize your water softener</a>. Doing so will mean the tank doesn&rsquo;t get full, which can lead to channeling. This leads to a large portion of the resin beads not being utilized and the beads at the bottom of the tank being overused. Over time, this will reduce the efficiency of your system, not to mention that the upfront cost of an oversized softener is unnecessarily high. If you have a timed regeneration cycle rather than a demand-based one, you&rsquo;ll also spend far more on replacing salt than you need to.</p></div>

Question 1

Do you need a conditioner with a water softener?

Accepted Answer

•

You should not use a water conditioner with a water softener because a water conditioner changes the chemistry of the water and causes the ion exchange in a softener to be ineffective. Choose a water softener if you have hard water or well water, and use a water conditioner if you need to remove certain contaminants.

Question 2

How do you get rid of heavy hard water deposits?

Accepted Answer

•

It depends on the type of surface. For instance, if you’re trying to get rid of hard water deposits on glass, you can spray vinegar onto the surface and wipe it off with a soft cloth or non-abrasive sponge. However, if the deposits are on granite or natural stone, it’s better to use baking soda and water rather than vinegar or other acidic cleaners.

Question 3

Is it OK to oversize a water softener?

Accepted Answer

•

It’s not a good idea to oversize your water softener. Doing so will mean the tank doesn’t get full, which can lead to channeling. This leads to a large portion of the resin beads not being utilized and the beads at the bottom of the tank being overused. Over time, this will reduce the efficiency of your system, not to mention that the upfront cost of an oversized softener is unnecessarily high. If you have a timed regeneration cycle rather than a demand-based one, you’ll also spend far more on replacing salt than you need to.

Question 4

Do you need a permit or license to install a water softener?

Accepted Answer

•

Whether you need a permit or license for a water softener installation depends on your location, as requirements vary significantly. Some municipalities require the installer to hold a plumbing license, some mandate a permit and an inspection, and others require both. In some areas, no special permit or license is needed at all.

To determine the rules in your area, you can contact your local building department or consult a local water softener installer or plumber. Often, only certified professionals are authorized to pull the necessary permits, and they will typically handle the entire permitting process for you. Regardless of local laws, it is always recommended to hire a licensed professional to ensure the system is sized and installed correctly. You can use Angi’s state licensing tool to check an installer’s license status.

Question 5

How do I install a water softener system?

Accepted Answer

•

You can install a water softener system by turning off the water supply, draining the water, and then connecting your device to the waterline. Next, you’ll fill your tank with the recommended amount of salt or brine (whichever your unit calls for; be sure to read the instructions). Turn the water supply on and check for leaks. You can opt to let your water run for a few minutes, then test it using strips.

The process of inspecting your water softener system is similar.