Get matched with top floor polishers in Atkinson, NE

Before starting on a full refinishing project, determine if your floors need to be completely sanded down to the bare wood or if the damage is shallow and mostly cosmetic. Deep scratches and gouges will require you to rough sand using a drum sander or belt sander, but small surface scratches or floors that have only lost their luster don’t need a complete overhaul. Instead, you can skip the rough sanding step and sand-screen the old finish with a buffer, removing only the top layer of polyurethane.

After carpet removal, prepare for new flooring by assessing the subfloor. You will want to address any imperfections to create a smooth and level base for installation. Remember, proper subfloor preparation is crucial for optimal new flooring results. Consider repairing and replacing damaged areas for a stable foundation. For both wood and concrete subfloors, consider sanding to remove any debris or adhesives remaining thoroughly. 

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.

The best way to clean vinyl floors is to vacuum or sweep away debris and then mop the floors using a mixture of warm water and dish soap or vinegar. You can also use store-bought cleaners if they’re marked safe for vinyl surfaces.