Get matched with top water heater pros in Kenmare, ND

Most standard residential water heaters, which are typically around 40 gallons and use 240 volts and between 3,500 and 5,500 watts, require a 30-amp, two-pole circuit breaker. For smaller, point-of-use water heaters using 120 volts and between 1,500 and 3,000 watts, a 30-amp breaker is also often adequate. However, some models may have different needs; units that use more watts than average may require a 40-amp breaker, while smaller units might only need a 20-amp breaker. Newer, tankless, or more energy-efficient models can also require a higher amperage. Having the correct breaker size is crucial for safe and efficient operation, so it's best to consult a licensed electrician to determine the specific needs of your water heater.

There are pros and cons to tankless water heaters. They are more efficient than traditional tank water heaters, and maintenance costs are lower. These units are also much more compact. On the other hand, they cost about twice as much to install as traditional tank water heaters and are more limited in terms of flow rate.

There are many issues that can cause cold showers, but the most likely is a problem with your water heater, especially if other fixtures also don’t get hot water. If it’s just your shower not getting hot water, you likely have a broken or damaged shower cartridge. You can replace this yourself or hire a plumber to do the work for you if you’re not comfortable working with plumbing.

If your gas water heater is over 20 years old, it should be replaced. Gas water heaters can last up to 12 years and while they can exceed this expectancy if well-maintained, a heater that's 20 years old would require replacement. The heater is unlikely to run as efficiently as a new model and could be more expensive to do so.