Top-rated floor polishers.

Best floor polishers near Rocky Point, NC

Enter your zip and get matched with up to 5 pros

Need a pro for your floor polishing project in Rocky Point, NC?

Select your specific project to find the pro for you.

Top-Rated Floor polishers in Rocky Point - Updated Nov 2026

Avatar for Grime Scene Invader, LLC
Grime Scene Invader, LLC
4.7(
17
)
Clean & Polish Flooring - For Business

Serving Rocky Point, NC and surrounding areas

Approved

In business since 2015

Free estimates

Emergency services offered

"These folks were fantastic. Arrived on time, polite, professional. We had asked for not only wall to wall carpet to be cleaned but an area rug as well. The service technician was concerned about the floors under the area rug and possible damage so he suggested taking the rug back to his facility for cleaning and drying. He provided this service at no additional charge. My rugs look brand new. I have told family and coworkers about this company. As a small business owner it is great to see good old fashioned customer service and pride in workmanship."
Response time7 hrs
Recommended by100%of homeowners
Avatar for Oden Pro Solutions
Oden Pro Solutions
New to Angi
Clean & Polish Flooring - For Business

Serving Rocky Point, NC and surrounding areas

Approved

Small jobs welcome

Offers commercial services

Family owned business with more than 10 years of cleaning experience. We mainly service Eastern and Central North Carolina but may be willing to travel to other regions. We strive for perfection, in our work, and to take some stress off of you!

Showing 1-10 of 37
Floor Polishers FAQs, answered by experts

Yes, but with caution. A floor grinder is intended to level and polish concrete, so it is a very powerful tool. To remove paint, the floor grinder should be set to 35 square feet per minute or less to minimize the pressure without the use of pocket weights. You might need to go over the surface two times to get any paint that has sunk into the concrete’s pores.

Before starting on a full refinishing project, determine if your floors need to be completely sanded down to the bare wood or if the damage is shallow and mostly cosmetic. Deep scratches and gouges will require you to rough sand using a drum sander or belt sander, but small surface scratches or floors that have only lost their luster don’t need a complete overhaul. Instead, you can skip the rough sanding step and sand-screen the old finish with a buffer, removing only the top layer of polyurethane.

To maintain tile and grout, clean the surfaces regularly with mild, non-abrasive cleaners and wipe up spills promptly to prevent buildup. It is also important to reseal the grout every 1-2 years to maintain its durability.

Dust mops are the best option for tackling dirt and dust on marble floors. Vacuums aren’t a good idea as the brushes and beater rolls can scratch and damage your marble floors. If you must use a vacuum, make sure your vacuum has a setting for hard floors, and take care not to apply too much pressure when rolling the vacuum across your marble floor.

Buffing will only remove scratches at the surface level of your flooring. You may also need to apply hardwood floor wax to restore the wax layer. To remove deeper scratches, you’ll need another floor repair method like sanding; however, if you sand the floor, you’ll also need to stain and seal it.

The Rocky Point, NC homeowners’ guide to floor polishing services

From average costs to expert advice, get all the answers you need to get your job done.