Best tree service pros near Hertford, NC

Only trim palm trees as needed, which is usually about once per year. However, don't stick to that schedule if the palm tree doesn't need it. Avoid trimming palm trees when possible. It’s best to trim palm trees only when you notice a buildup of dead fronds. That said, leave the brown fronds during the dormant season because this organic matter helps protect the tree from the cooler weather.

Often, it’s the homeowner’s responsibility to handle the aftermath when a neighbor’s tree falls on their property. But if a tree has been obviously dead for a significant period of time and caused damage when it fell, a case can be made that the owner should have removed it, especially if the neighbor wrote you a letter about the tree or asked you to take it down. This can be grounds for a successful lawsuit in claims court and is a good reason to always pay attention to your trees and remove dead trees before they fall.

There are a few things you should look for in a stump removal company to make sure you’ll be satisfied with the results:

• Proper business licensing and insurance

• History of positive reviews

• Good rating with the Better Business Bureau

We also recommend asking any company you’re considering the following questions to help find the best value:

• Will you remove the roots as well as the stump?

• Will you haul away wood chips or large portions of the stump?

• What method will you use to remove the stump?

There are several methods to hollow out a tree stump, and the best one depends on your tools, experience, and priorities. Common methods include using a chisel and hammer, a chainsaw, or burning.

• Chisel and Hammer: This is often considered the easiest approach for those with limited tools or experience, though it is the most time-consuming.

• Chainsaw: Using a chainsaw is the fastest method, but it comes with significant safety risks, especially for inexperienced users.

• Burning: This can be an effective method, but it is not recommended unless you can first drill holes into the stump. Without holes, the stump will be difficult to light and may not burn completely through.

A power drill with at least a ⅜-inch diameter bit can make the job quicker and easier, regardless of the primary method. While you can use a chisel or chainsaw without a drill, it will require more time and effort. Always wear protective goggles and thick gloves, as splinters are an inevitable risk.